1000 lb "Paveway II" LGB (UK) Bombs (2 pcs) (Tornado, Eurofighter,Buccaneer, Harrier) (3D Printed) Scale 1:72 ResKit RS72-0380 for Aircraft Model Kit

ResKit RS72-0380 is a 3D printed resin Weapons Set featuring 1000 lb Paveway II (UK) laser guided bombs (2 pcs) for 1/72 aircraft builds. The set emphasizes clean bomb body proportions, defined guidance section detail and sharp fin geometry, helping external stores retain clarity in small scale.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/72 scale aircraft models.

On RAF strike aircraft, paired LGBs are often mounted under the wings or fuselage stations. Replacing simplified kit parts can improve surface definition and provide a balanced two-bomb configuration for modern or late-Cold War loadouts.

For modelers: carefully remove supports around the fins and guidance nose, then dry-fit to pylons before painting. Install bombs in mirrored positions and verify alignment from front and side views to maintain symmetry (kit-dependent).

Compatible aircraft

• Harrier
• Eurofighter Typhoon
• Tornado
• Blackburn Buccaneer

Product Specifications

• Subject: 1000 lb Paveway II (UK) LGB bombs
• Scale: 1/72 (also written as 1:72)
• Product type: Weapons Set
• Type of equipment: Aircraft
• Recommended kit: Any / Universal - for compatible 1/72 kits (kit-dependent)
• Service / Subject country: United Kingdom
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS72-0380

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Arms and Weapons or compare with Arms and Weapons (all brands). For matching builds, see Aircraft Model Kits and 1/72 Aircraft Model Kits.

FAQ

Will these bombs fit all listed aircraft kits?

The set is marked Any / Universal, but pylon spacing and rack types vary between manufacturers. Always dry-fit before final installation (kit-dependent).

How should I align a two-bomb load?

Install the bombs in mirrored positions and check alignment from multiple angles while the adhesive sets to maintain a balanced configuration.

Do 3D printed LGBs require special preparation?

Remove supports carefully, wash the parts, and apply a thin primer coat to preserve fine guidance and fin detail in 1/72.