A/A42R-1 Buddy Air Refueling Store (1 pcs) (F/A-18, S-3, MQ-25, A-6, EA-6, A-7, A-4) (3D Printed) Scale 1:32 ResKit RS32-0399 for Aircraft Model Kit

ResKit RS32-0399 Fuel Tank Set features the A/A42R-1 Buddy Air Refueling Store (1 pcs) for 1/32 aircraft models, produced as a 3D printed part for clean geometry and sharp surface definition on an external store.

This item suits builds where the centerline or pylon-mounted store becomes a focal point, so straight alignment and clean joints matter as much as paintwork.

For modelers: test-fit to your kit pylon/adapter points first (kit-dependent) and set the final angle before glue fully cures. Remove any supports in small steps, then apply light primer coats to preserve fine edges and panel detail.

Compatible aircraft

• F/A-18 Hornet/Super Hornet
• Lockheed S-3 Viking
• Boeing MQ-25 Stingray
• Grumman A-6 Intruder
• Grumman EA-6 Prowler
• LTV A-7 Corsair II
• Douglas A-4 Skyhawk

Product Specifications

• Subject: A/A42R-1 Buddy Air Refueling Store
• Compatible aircraft: F/A-18 Hornet/Super Hornet; Lockheed S-3 Viking; Boeing MQ-25 Stingray; Grumman A-6 Intruder; Grumman EA-6 Prowler; LTV A-7 Corsair II; Douglas A-4 Skyhawk
• Scale: 1/32 (also written as 1:32)
• Product type: Fuel Tank Set
• Type of equipment: Aircraft
• Recommended kit: Any / Universal
• Service / Subject country: USA
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS32-0399

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Fuel Tanks or compare with Fuel Tanks (all brands). For matching builds, see Aircraft Model Kits and 1/32 Aircraft Model Kits.

FAQ

Why is the item listed as Any / Universal?

It means the set is not tied to a single kit brand. Attachment points and pylons can differ by kit, so test-fit and set the final angle before glue cures (kit-dependent).

What is the best way to mount an external store cleanly?

Use a firm dry-fit to establish alignment, then add glue in small amounts and re-check the centerline and side view so the store sits parallel and straight.

How should I handle 3D printed parts for a smooth finish?

Remove supports progressively, refine contact points, then prime lightly. A second thin primer pass after spot-sanding helps keep edges crisp without filling detail.