A/A42R-1 Buddy Air Refueling Store (1 pcs) (F/A-18, S-3, MQ-25, A-6, EA-6, A-7, A-4) (3D Printed) Scale 1:48 ResKit RS48-0399 for Aircraft Model Kit

ResKit RS48-0399 is a Fuel Tank Set with one A/A42R-1 Buddy Air Refueling Store for 1/48 aircraft builds. This 3D printed set helps you add a distinctive centerline/underwing store with crisp panel lines and clean pod geometry, which is hard to keep sharp on small cylindrical shapes.

It works as a focal external store on modern and late-generation carrier aviation subjects, especially when the pylon area is left exposed and easy to inspect. Mounting points and sway brace positions vary by kit and pylon choice, so final fit and alignment are kit-dependent.

For modelers: remove supports with a fine saw, then dry-fit the pod to the intended pylon before paint. If you need to adjust the mounting interface, do it gradually and keep the store centered to avoid a visible tilt when viewed from the front.

Compatible aircraft

• F/A-18 Hornet/Super Hornet
• Lockheed S-3 Viking
• Boeing MQ-25 Stingray
• Grumman A-6 Intruder
• Grumman EA-6 Prowler
• LTV A-7 Corsair II
• Douglas A-4 Skyhawk

Product Specifications

• Subject: A/A42R-1 Buddy Air Refueling Store (1 pc)
• Scale: 1/48 (also written as 1:48)
• Product type: Fuel Tank Set
• Type of equipment: Aircraft
• Recommended kit: Any / Universal (kit-dependent)
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS48-0399

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Fuel Tanks or compare with Fuel Tanks (all brands). For matching builds, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Is this suitable for any 1/48 kit of the listed aircraft?

The store is for 1/48 builds, but pylons and mounting points differ by kit. Dry-fit to your chosen pylon and confirm alignment and clearance before final attachment (kit-dependent).

How should I prepare 3D printed parts for painting?

Remove supports with a fine saw, lightly sand contact points, then prime early to reveal any remaining support marks before paint.

When should I attach the store to the model?

It is usually easier to prep and paint the store separately, then install it after you confirm the final pylon position and the model’s stance.