AASM-250 Hammer Thermally Protected Bombs (6 pcs) (Mirage 2000, Rafale, MiG-29) (3D Printed) Scale 1:48 ResKit RS48-0463 for Aircraft Model Kit

ResKit RS48-0463 is a 3D printed Weapons Set of AASM-250 Hammer thermally protected bombs (6 pcs) for 1/48 aircraft builds. The set focuses on clean body geometry and sharp fin edges, helping guided stores look consistent across multiple stations after primer and paint.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/48 scale aircraft models.

Bombs with guidance and tail/fin assemblies draw attention because their shapes are more complex than simple free-fall stores. This set supports several compatible aircraft while keeping final rack and pylon interfaces kit-dependent.

For modelers: test-fit the bombs to your kit racks early to confirm spacing and clearance. Remove supports carefully around fins, wash parts and let them dry fully, then apply a light primer coat to check edges and surface finish before final painting.

Compatible aircraft

• Dassault Mirage 2000
• Dassault Rafale
• Mikoyan-Gurevich MiG-29 Fulcrum

Product Specifications

• Subject: AASM-250 Hammer Thermally Protected Bombs (6 pcs)
• Scale: 1/48 (also written as 1:48)
• Product type: Weapons Set
• Type of equipment: Aircraft
• Recommended kit: Any / Universal (kit-dependent)
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS48-0463

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Arms and Weapons or compare with Arms and Weapons (all brands). For matching projects, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Will these bombs fit any 1/48 kit?

They are listed as Any / Universal, but racks and mounting points vary by kit. Test-fit to your kit pylons/racks and adjust the attachment area as needed.

How do I avoid damaging fins during cleanup?

Cut supports in small steps and avoid twisting. A light primer coat can help reveal where gentle smoothing is needed without heavy sanding.

How can I keep multiple stores consistent?

Prime and paint the full batch together and dry-fit all bombs on the racks at the same time to keep spacing and angles uniform.