AGM-114A/B Hellfire Missiles (4 pcs) (AH-64, AH-1, UH-60, SH-60, Eurocopter Tiger, OH-58, RAH-66, MQ-1, MQ-9) (3D Printed) Scale 1:48 ResKit RS48-0326 for Aircraft / Helicopters Model Kit

ResKit RS48-0326 is a 1/48 AGM-114A/B Hellfire missiles set with 4 pieces, produced in 3D printed resin for consistent body geometry and crisp fin edges. In 1/48, stores are often viewed at close range, so clean fin thickness and uniform symmetry across all four missiles make a noticeable difference on a loaded rack.

Hellfires tend to sit in aligned pairs, which makes small differences in length, fin angle, or tip shape easy to spot. Replacing kit missiles can help keep the whole launcher station looking neat and evenly spaced without spending extra time reshaping small fins.

For modelers: dry-fit each missile to your rails or launchers before painting and mark the contact points so both sides match. Prime lightly to preserve edges, paint in thin coats, and use a simple straight edge as a guide when installing to keep all four missiles aligned.

Compatible aircraft

• AH-64 Apache
• Bell AH-1G Cobra
• Bell AH-1Z Viper
• Sikorsky MH-60 Jayhawk
• Sikorsky UH-60 Black Hawk
• Sikorsky SH-60 Seahawk
• Sikorsky HH-60
• Sikorsky S-70A-27
• Eurocopter
• Bell OH-58 Kiowa
• RAH-66 Comanche
• MQ-9 Reaper
• MQ-1 Predator

Product Specifications

• Subject: AGM-114A/B Hellfire missiles (4 pcs)
• Scale: 1/48 (also written as 1:48)
• Product type: Weapons Set
• Type of equipment: Aircraft / Helicopters
• Recommended kit: Any / Universal
• Service / Subject country: USA
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS48-0326

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Arms and Weapons or compare with Arms and Weapons (all brands). For matching builds, see Helicopter Model Kits and 1/48 Helicopter Model Kits.

FAQ

Will these missiles fit any 1/48 kit that can carry Hellfires?

The set is listed as Any / Universal, but rail and launcher interfaces can be kit-dependent. Dry-fit to your kit’s pylons/rails and adjust the contact point as needed.

How should I prepare 3D printed resin missiles before painting?

Wash the parts, allow them to dry fully, then apply a thin primer coat. This improves paint adhesion while keeping fin edges crisp.

How can I keep all four missiles aligned evenly?

Install using a consistent sequence and check fin planes against a straight edge while the adhesive cures. Marking the mount points beforehand helps both sides match.