AGM-114K Hellfire II Missiles (4 pcs) (AH-64, AH-1, UH-60, SH-60, Eurocopter Tiger, OH-58, RAH-66, MQ-1, MQ-9) (3D Printed) Scale 1:72 ResKit RS72-0329 for Aircraft / Helicopters Model Kit

ResKit RS72-0329 is a 3D printed resin Weapons Set featuring AGM-114K Hellfire II missiles (4 pcs) for 1/72 aircraft and helicopter builds. The set focuses on defined body proportions and crisp fin detail, helping small-scale stores retain sharp geometry under primer and paint.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/72 scale aircraft models.

On rotary-wing platforms and light attack aircraft, external missiles are highly visible on pylons and launch rails. Replacing simplified kit parts can improve surface clarity and provide a consistent four-missile configuration.

For modelers: remove supports carefully around the fins and check alignment on the launch rails before painting. Install missiles in balanced pairs and verify symmetry from front and top views to maintain a clean presentation (kit-dependent).

Compatible aircraft

• AH-64 Apache
• Bell AH-1G Cobra
• Bell AH-1Z Viper
• Sikorsky MH-60 Jayhawk
• Sikorsky UH-60 Black Hawk
• Sikorsky SH-60 Seahawk
• Sikorsky HH-60
• Sikorsky S-70A-27
• Eurocopter
• Bell OH-58 Kiowa
• RAH-66 Comanche
• MQ-9 Reaper
• MQ-1 Predator

Product Specifications

• Subject: AGM-114K Hellfire II missiles
• Scale: 1/72 (also written as 1:72)
• Product type: Weapons Set
• Type of equipment: Aircraft / Helicopter
• Recommended kit: Any / Universal - for compatible 1/72 kits (kit-dependent)
• Service / Subject country: USA
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS72-0329

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Arms and Weapons or compare with Arms and Weapons (all brands). For matching builds, see Helicopter Model Kits and 1/72 Helicopter Model Kits.

FAQ

Will these missiles fit all listed platforms?

The set is labeled Any / Universal, but launcher types and rail spacing vary between kits. Always dry-fit before final installation (kit-dependent).

How should I align a four-missile load?

Install missiles in mirrored pairs and check alignment from multiple angles while the adhesive sets to maintain symmetry.

Do 3D printed missiles need special preparation?

Carefully remove supports, wash the parts, and apply a thin primer coat to preserve fin and surface detail in 1/72 scale.