AGM-12C Bullpup B Missiles (2 pcs) (A-4, A-5, A-6, A-7, F-4, F-8, F-100, F-105, P-3 Orion, Sea Vixen, Buccaneer) (3D Printed) Scale 1:48 ResKit RS48-0429

ResKit RS48-0429 includes AGM-12C Bullpup B missiles in 1/48 as a 2-piece 3D printed weapons set. The printing helps keep the missile body lines and fin geometry crisp, which is especially noticeable when the stores are mounted close to pylons where alignment and symmetry stand out.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/48 scale aircraft models.

This set is useful for aircraft builds that need a matched pair of Bullpup missiles with consistent proportions, avoiding soft fin edges that can disappear after primer and paint.

For modelers: dry-fit the missiles to your kit pylons/rails first and confirm mounting angle and clearance (kit-dependent). Remove supports gradually and check fin alignment from the rear; a thin primer coat helps reveal any contact marks before final paint.

Compatible aircraft

• Douglas A-4 Skyhawk
• North American A-5/RA-5 Vigilante
• Grumman A-6 Intruder
• Grumman EA-6 Prowler
• LTV A-7 Corsair II
• McDonnell Douglas F-4 Phantom II
• Vought F-8 Crusader
• North American F-100 Super Sabre
• Republic F-105 Thunderchief
• Lockheed P-3 Orion, Buccaneer
• De Havilland DH.110 Sea Vixen

Product Specifications

• Subject: AGM-12C Bullpup B Missiles (2 pcs)
• Scale: 1/48 (also written as 1:48)
• Product type: Weapons Set
• Type of equipment: Aircraft
• Recommended kit: Any / Universal
• Service / Subject country: USA
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS48-0429

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Arms and Weapons or compare with Arms and Weapons (all brands). For matching projects, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Is this set kit-specific?

The set is listed as Any / Universal, but pylons, rails, and mounting points vary between kit manufacturers, so final fit is kit-dependent.

How do I keep both missiles aligned evenly?

Test-fit them as a pair and compare angles from the front and side. Make small adjustments at the mounting interface before glue cures.

Any tips for preparing 3D printed fins?

Remove supports carefully and sand lightly on a flat surface to keep fin edges straight. A thin primer coat helps reveal contact marks before paint.