AGM-142 Popeye/Have Nap Missiles (2 pcs) (F-4E, F-15I, F-111C, B-52G/H) (3D Printed) Scale 1:48 ResKit RS48-0517 for Aircraft Model Kit

ResKit RS48-0517 is a 3D printed AGM-142 Popeye/Have Nap Missiles Weapons Set (2 pcs) for 1/48 aircraft builds. The set is designed to give you sharper missile body lines and cleaner fin geometry, which helps these large stores look straight and consistent when mounted.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/48 scale aircraft models.

This weapons set is useful when you want a tidy underwing loadout with more defined edges than many kit parts, especially on builds where the pylons and store alignment are very visible.

For modelers: plan your mounting early: test-fit missiles with the pylon(s) and check clearance to gear doors and adjacent stores. For a stronger joint, pin the attachment point with thin wire, then prime lightly to preserve the printed surface detail.

Compatible aircraft

• McDonnell Douglas F-4 Phantom II
• McDonnell Douglas F-15 Eagle/Strike Eagle
• General Dynamics F-111 Aardvark
• Boeing B-52 Stratofortress

Product Specifications

• Subject: AGM-142 Popeye/Have Nap Missiles (2 pcs)
• Scale: 1/48 (also written as 1:48)
• Product type: Weapons Set
• Type of equipment: Aircraft
• Recommended kit: Any / Universal
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Subject country: USA / Israel / Australia
• Material: Resin / 3D Printed
• SKU: RS48-0517

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Arms and Weapons or compare with Arms and Weapons (all brands). For matching builds, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ decision: Included because this is a 3D printed weapons set with kit-dependent mounting/alignment and a defined compatible aircraft list.

FAQ

Will these missiles fit any 1/48 kit?

They are listed as Any / Universal, but pylon interfaces are kit-dependent. Confirm your kit pylon style and test-fit for alignment and clearance before final assembly.

How do I avoid crooked fins or a twisted look?

Use a flat surface or simple jig while gluing, and check symmetry from front and top views. Let one side cure before handling to avoid shifting.

What prep works well for 3D printed parts before painting?

Wash parts, remove any remaining print contact points carefully, then use a light primer coat so surface detail stays crisp.