AGM-62 Walleye I ER missiles (2 pcs) with AN/AWG-16 data link pod (1 pcs) (A-4, A-6, A-7, F-4, F/A-18) (3D Printed) Scale 1:48 ResKit RS48-0532

ResKit RS48-0532 is a 3D printed set for AGM-62 Walleye I ER missiles in 1/48, including 2 pcs plus the AN/AWG-16 data link pod in 1 pc. The standout detail here is the pairing of weapon and guidance pod, which helps you build a more convincing stores configuration instead of hanging a single item without the associated equipment.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/48 scale aircraft models.

This set is useful on carrier-based aircraft builds where underwing stores are prominent and the overall loadout balance matters visually, especially when you want the pylons to look purposefully equipped rather than generic.

For modelers: plan the pylon positions early and dry-fit the pod and weapons together to confirm clearance and symmetry. Keep the data link pod separate through most of painting, then attach late to avoid handling damage on small fins and edges.

Compatible aircraft

• A-4 Skyhawk,
• A-6 Intruder
• A-7 Corsair II,
• F-4 Phantom II
• F/A-18 Hornet/Super Hornet

Product Specifications

• Subject: AGM-62 Walleye I ER missiles (2 pcs) with AN/AWG-16 data link pod (1 pcs)
• Scale: 1/48 (also written as 1:48)
• Product type: Weapons Set
• Type of equipment: Aircraft
• Recommended kit: Any / Universal
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS48-0532

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Arms and Weapons or compare with Arms and Weapons (all brands). For matching builds, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Is this set universal for any 1/48 kit?

It is listed as Any / Universal, but pylon styles and mounting points are kit-dependent. Dry-fit the stores and adjust the contact faces if needed.

Should I install the data link pod on the same pylon as the weapon?

Placement is kit- and loadout-dependent. Test-fit your chosen pylons to ensure the pod clears landing gear doors and other stores and sits parallel to the aircraft centerline.

How do I handle small 3D printed fins and edges during finishing?

Wash and prime the parts, then keep sanding minimal around edges. Leaving the finest pieces on supports until cleanup is complete can help prevent accidental breakage.