AGM-62 Walleye II missiles (2 pcs) with AN/AWG-16 data link pod (1 pcs) (A-4, A-6, A-7, F-4, F/A-18) (3D Printed) Scale 1:32 ResKit RS32-0563

ResKit RS32-0563 is a 1/32 weapons set with AGM-62 Walleye II missiles (2 pcs) and an AN/AWG-16 data link pod (1 pcs), produced as 3D printed parts. The practical advantage is a consistent pair of missiles plus the matching pod, so your stores layout looks planned as a single system rather than a mix of unrelated parts.

This set supports aircraft projects where the Walleye II and its data link pod are part of the chosen configuration, helping keep pylon stations visually coherent and symmetry-friendly on the finished model.

For modelers: plan the stations first and dry-fit both missiles and the pod to confirm clearance and parallel alignment. Remove any supports gradually, true the mating faces, and set both missiles at the same angle before glue; rails and adapters are kit-dependent.

Compatible aircraft

• A-4 Skyhawk,
• A-6 Intruder
• A-7 Corsair II,
• F-4 Phantom II
• F/A-18 Hornet/Super Hornet

Product Specifications

• Subject: AGM-62 Walleye II missiles (2 pcs) with AN/AWG-16 data link pod (1 pcs)
• Scale: 1/32 (also written as 1:32)
• Product type: Weapons Set
• Type of equipment: Aircraft
• Recommended kit: Any / Universal
• Service / Subject country: USA
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS32-0563

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Arms and Weapons or compare with Arms and Weapons (all brands). For matching builds, see Aircraft Model Kits and 1/32 Aircraft Model Kits.

FAQ

What is included in the set?

The package includes two AGM-62 Walleye II missiles and one AN/AWG-16 data link pod as unpainted, unassembled parts.

Do 3D printed parts need special preparation?

Carefully remove any supports, then wash the parts with mild detergent before priming to improve paint adhesion and keep fine edges sharp.

Will this fit any 1/32 kit of the compatible aircraft?

The set is intended for 1/32 projects of the listed aircraft, but pylons, rails, and adapters vary by kit, so final fit and positioning are kit-dependent.

Any practical tip for a paired missile setup?

Dry-fit both missiles together and match their pitch and spacing before glue so the pair reads symmetrical from front and underside views.