AGM-62 Walleye II missiles (2 pcs) with AN/AWG-16 data link pod (1 pcs) (A-4, A-6, A-7, F-4, F/A-18) (3D Printed) Scale 1:48 ResKit RS48-0563

ResKit RS48-0563 is a 3D printed set for AGM-62 Walleye II missiles in 1/48, including 2 pcs plus the AN/AWG-16 data link pod in 1 pc. The practical advantage is having a matched weapon-and-pod combination, letting you represent a more complete stores fit with consistent surface definition across all parts.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/48 scale aircraft models.

This set is helpful on aircraft builds where the underside loadout is highly visible, and where a dedicated pod alongside the weapons makes the configuration look purpose-built rather than generic.

For modelers: map out your pylon plan before painting and test-fit both weapons and pod to confirm spacing and symmetry. Paint the pod separately and install it late, after decaling and clear coats, to reduce the chance of snapping small printed edges during handling.

Compatible aircraft

• A-4 Skyhawk,
• A-6 Intruder
• A-7 Corsair II,
• F-4 Phantom II
• F/A-18 Hornet/Super Hornet

Product Specifications

• Subject: AGM-62 Walleye II missiles (2 pcs) with AN/AWG-16 data link pod (1 pcs)
• Scale: 1/48 (also written as 1:48)
• Product type: Weapons Set
• Type of equipment: Aircraft
• Recommended kit: Any / Universal
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS48-0563

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Arms and Weapons or compare with Arms and Weapons (all brands). For matching builds, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Is this set universal for any 1/48 kit?

It is listed as Any / Universal, but pylon styles and locating points are kit-dependent. Dry-fit the weapons and pod and adjust the mounting faces as needed.

Do I need to place the pod on a specific station?

Station choice is kit-dependent. Use test-fitting to ensure clearance from landing gear doors and adjacent stores, and keep the pod aligned parallel to the centerline.

What is a safe assembly order for 3D printed stores?

Clean and wash parts, prime and paint on holders, then attach after most finishing steps. This keeps sharp printed edges protected and reduces handling marks.