AGM-84 (A,D) Harpoon Missiles (2 pcs) (P-8A, A-6, A-7E, B-1B, B-52H, F-111C, F-16, F/A-18, F-20, Nimrod MR2, AV-8B, P-3, S-3) (3D Printing) Scale 1:48 ResKit RS48-0416 for Aircraft Model Kit

ResKit RS48-0416 is a 3D printed Weapons Set of AGM-84 (A,D) Harpoon missiles (2 pcs) for 1/48 aircraft builds. The set is aimed at clean missile body geometry and sharp fin edges, helping large underwing stores look straight and consistent after primer and paint.

Harpoon missiles are long, highly visible stores that can dominate the look of a loadout. Replacing kit parts can improve edge definition and keep the overall profile more refined, while final mounting and pylon interfaces remain kit-dependent.

For modelers: dry-fit the missiles to your kit pylons early and confirm clearance, as spacing varies between aircraft and kit brands. Remove supports carefully around fin roots, wash and fully dry the parts, then apply a light primer coat to check alignment before final finish.

Compatible aircraft

• Boeing P-8A Poseidon
• Grumman A-6 Intruder
• Grumman EA-6 Prowler
• LTV A-7 Corsair II
• Rockwell B-1 Lancer
• Boeing B-52 Stratofortress
• General Dynamics F-111 Aardvark
• General Dynamics F-16 Fighting Falcon
• F/A-18 Hornet/Super Hornet
• F-20 Tigershark
• Nimrod
• Harrier
• Lockheed S-3 Viking
• Lockheed P-3 Orion

Product Specifications

• Subject: AGM-84 (A,D) Harpoon Missiles (2 pcs)
• Scale: 1/48 (also written as 1:48)
• Product type: Weapons Set
• Type of equipment: Aircraft
• Recommended kit: Any / Universal (kit-dependent)
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS48-0416

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Arms and Weapons or compare with Arms and Weapons (all brands). For matching projects, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Will these missiles fit any 1/48 kit?

They are listed as Any / Universal, but pylon shapes and mounting points vary between kits. Test-fit the contact area and adjust as needed before final glue.

How should I prepare 3D printed missiles before painting?

After support cleanup, wash the parts to remove residue, let them dry completely, then apply a light primer coat to reveal any areas that may need gentle smoothing.

How can I keep long missiles straight and aligned?

Prime and paint on a flat support, then dry-fit both missiles at the same time to check parallel alignment and clearance before final installation.