AIM-7F High Vis Sparrow III Missiles (4 pcs) (F-4, F-5, F-15, F-16, F-14, F/A-18) (3D Printed) Scale 1:32 ResKit RS32-0457 for Aircraft Model Kit

ResKit RS32-0457 AIM-7F High Vis Sparrow III Missiles (4 pcs) is a 3D printed set for 1/32 aircraft builds. The parts focus on clean missile bodies and sharp fin edges, helping stores look consistent and evenly aligned on visible stations.

This set is useful when your build includes air-to-air stores and you want symmetrical underwing or fuselage-mounted details that hold up in close-up viewing.

For modelers: remove 3D print supports in small steps (a fine saw helps), then smooth contact points and wash parts before primer. Dry-fit to your kit rails or adapters first to confirm alignment before final glue sets.

Compatible aircraft

• McDonnell Douglas F-4 Phantom II
• Northrop F-5 Freedom Fighter/Tiger II
• McDonnell Douglas F-15 Eagle/Strike Eagle
• General Dynamics F-16 Fighting Falcon
• Grumman F-14 Tomcat
• F/A-18 Hornet/Super Hornet

Product Specifications

• Subject: AIM-7F High Vis Sparrow III Missiles (4 pcs)
• Scale: 1/32 (also written as 1:32)
• Product type: Arms and Weapons
• Type of equipment: Aircraft
• Recommended kit: Any / Universal
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS32-0457

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Arms and Weapons or compare with Arms and Weapons (all brands). For matching builds, see Aircraft Model Kits and 1/32 Aircraft Model Kits.

FAQ

Do 3D printed missiles need special preparation?

Yes. Remove supports carefully, smooth the contact points, and wash the parts before priming. Use thin primer coats to preserve fin sharpness.

Will these missiles fit any 1/32 kit for the compatible aircraft?

Rails, adapters, and mounting points vary by kit. Dry-fit to your kit parts first and adjust only the contact faces if needed.

How can I keep the fins aligned symmetrically?

Test-fit both sides and compare alignment from the front and rear. Set orientation before final glue cures so all missiles sit evenly.