AIM-7F Low Vis Sparrow III Missiles (4 pcs) (F-4, F-5, F-15, F-16, F-14, F/A-18) (3D Printed) Scale 1:32 ResKit RS32-0458 for Aircraft Model Kit

ResKit RS32-0458 is a 1/32 set of AIM-7F Low Vis "Sparrow III" missiles (4 pcs) for aircraft builds. In this scale, fin alignment and nose profile are easy to notice, so consistent geometry across all four missiles helps keep the loadout looking tidy.

The set is listed as a universal accessory item, so confirm the mounting interface and spacing on your pylons/launch rails before final assembly.

For modelers: remove supports carefully, then dry-fit each missile to the intended rail to check contact points and alignment. Prime lightly to keep edges sharp, and paint in thin coats so small surface features stay readable.

Compatible aircraft

• McDonnell Douglas F-4 Phantom II
• Northrop F-5 Freedom Fighter/Tiger II
• McDonnell Douglas F-15 Eagle/Strike Eagle
• General Dynamics F-16 Fighting Falcon
• Grumman F-14 Tomcat
• F/A-18 Hornet/Super Hornet

Product Specifications

• Subject: AIM-7F Low Vis "Sparrow III" missiles
• Scale: 1/32 (also written as 1:32)
• Product type: Arms and Weapons
• Set contents: 4 pcs
• Type of equipment: Aircraft
• Recommended kit: Any / Universal
• Country of origin: USA
• Category: Resin & 3D accessories
• Manufacturer: RESKIT (Accessories for Scale Plastic Kits)
• Country/Region of Manufacture: Ukraine
• Material: Resin / 3D Printed
• Model (SKU): RS32-0458
• Condition: New in Box

This item is part of ResKit and belongs to Aftermarket. Browse related items in ResKit Arms and Weapons and Arms and Weapons, or use Aircraft Aftermarket. For matching builds, see 1/32 Aircraft Model Kits and Aircraft Model Kits.

FAQ

Do I need to modify the launch rails to fit?

Fit is kit-dependent. Dry-fit first and adjust contact points gradually so all four missiles sit at the same angle.

What is a clean way to keep all missiles aligned uniformly?

Use one rail as a reference, set the first missile straight, then match the remaining three to the same pitch and yaw before glue fully cures.

How should I prep 3D printed parts before painting?

Remove supports carefully, clean the surface, and apply a light primer coat. Avoid heavy primer layers that can soften fine edges.