AIM-9L Sidewinder Missiles (4 pcs) (F-4, F-5, F-15, F-16, F-18, F-22, F-111, Harrier, Tornado, Eurofighter, Hawk, Gripen) (3D Printed) Scale 1:32 ResKit RS32-0481 for Aircraft / Helicopters Model Kit

ResKit RS32-0481 includes AIM-9L Sidewinder missiles in 1/32 as a 4-piece 3D printed set for external stores. The printing helps keep fin edges, body lines, and overall symmetry consistent across all four missiles, which is especially noticeable when you mount matched pairs on multiple stations.

This set is useful when you want a uniform air-to-air loadout with clean geometry and consistent surface definition across different pylons/rails on compatible aircraft or helicopter builds.

For modelers: dry-fit each missile to the kit rail/launcher first and check that all four sit at the same angle (kit-dependent). Remove supports gradually and keep fin edges straight by sanding lightly on a flat surface; a thin primer coat helps reveal contact marks before paint.

Compatible aircraft

• McDonnell Douglas F-4 Phantom II
• Northrop F-5 Freedom Fighter/Tiger II
• McDonnell Douglas F-15 Eagle/Strike Eagle
• General Dynamics F-16 Fighting Falcon
• F/A-18 Hornet/Super Hornet
• Lockheed Martin F-22 Raptor
• General Dynamics F-111 Aardvark
• Harrier
• Tornado
• Eurofighter Typhoon
• Hawk
• Saab JAS 39 Gripen

Product Specifications

• Subject: AIM-9L Sidewinder Missiles (4 pcs)
• Scale: 1/32 (also written as 1:32)
• Product type: Weapons Set
• Type of equipment: Aircraft
• Recommended kit: Any / Universal
• Service / Subject country: USA
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS32-0481

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Arms and Weapons or compare with Arms and Weapons (all brands). For matching builds, see Helicopter Model Kits and 1/32 Aircraft Model Kits.

FAQ

Is this set kit-specific?

The set is listed as Any / Universal, but rails, launchers, and mounting points vary between kits, so final fit is kit-dependent. Always dry-fit before glue.

How do I keep all four missiles aligned evenly?

Test-fit them as a complete set and compare angles from the front and side. Make small adjustments at the rail interface so each missile sits parallel and symmetrical.

Any preparation tips for 3D printed fins?

Remove supports in small steps and sand on a flat surface to keep edges straight. A thin primer coat helps confirm the fins and body lines stay crisp before final paint.