AIR-2 Genie aircraft external-store accessory (1 pcs) (F-89, F-101, F-102, F-106) (3D Printed) Scale 1:48 ResKit RS48-0473 | Unassembled Plastic Display Model

ResKit RS48-0473 is a 3D printed scale model accessory set featuring the AIR-2 Genie air-to-air external stores (1 pc) for 1/48 aircraft builds. The part is designed for clean body geometry and sharp fin edges, helping a distinctive single-store loadout look consistent after primer and paint.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/48 scale aircraft models.

Single large stores tend to draw attention on finished models, especially on classic interceptor subjects where the undersides and bays are easy to view. This set helps refine the external store appearance while keeping final mounting interfaces kit-dependent.

For modelers: plan the mounting early and test-fit the external stores in your kit bay/rail area before painting, since attachment points vary by kit. Remove supports carefully around fin roots, wash and fully dry the part, then apply a light primer coat to check edge definition before final finish.

Compatible aircraft

• Northrop F-89 Scorpion
• McDonnell F-101 Voodoo
• Convair F-102 Delta Dagger
• Convair F-106 Delta Dart

Product Specifications

• Subject: AIR-2 Genie air-to-air external stores (1 pcs)
• Scale: 1/48 (also written as 1:48)
• Product type: scale model accessory set
• Type of equipment: Aircraft
• Recommended kit: Any / Universal (kit-dependent)
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS48-0473

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit scale accessories or compare with scale model accessories. For matching projects, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Will this part fit any 1/48 kit of the compatible aircraft?

It is listed as Any / Universal, but bay/rail interfaces and mounting points vary by kit brand. Test-fit first and adjust the contact area if needed before final glue.

How should I prepare the 3D printed part before painting?

After support cleanup, wash the part to remove residue, let it dry completely, then apply a light primer coat to reveal any areas that may need gentle smoothing.

How can I keep fins and edges clean during cleanup?

Cut supports in small steps and avoid twisting. A light pass after priming is usually safer than heavy sanding on bare resin.

Important: This is a non-functional scale model accessory intended only for plastic model kits, dioramas, and display builds. It is not usable as a real-world component or self-defense product.