AN / ALQ-184 ECM pod (short length version) (A-10, F-4G, F-16, C-130) (3D printing) Scale 1:32 ResKit RS32-0411 for Aircraft Model Kit

ResKit RS32-0411 is an ECM/Data Link Pod set for AN / ALQ-184 in the short length version for 1/32 aircraft builds. The part is intended as an external store sub-assembly you can paint and install late in the project, keeping the airframe handling simple during earlier steps.

This item is listed for several aircraft types and can be used when your kit provides suitable pylons or mounting points. A quick dry-fit against the kit pylon interface helps avoid alignment surprises.

For modelers: if your part has printing supports, remove them in small steps and keep the contact faces flat. Test-fit to the pylon before paint, then finish the pod separately and attach it after weathering to reduce handling marks.

Compatible aircraft

• Fairchild Republic A-10 Thunderbolt II
• McDonnell Douglas F-4 Phantom II
• General Dynamics F-16 Fighting Falcon
• Lockheed C-130 Hercules

Product Specifications

• Subject: AN / ALQ-184 ECM pod (short length version)
• Scale: 1/32 (also written as 1:32)
• Product type: ECM/Data Link Pod
• Type of equipment: Aircraft
• Compatible aircraft: Fairchild Republic A-10 Thunderbolt II
• Compatible aircraft: McDonnell Douglas F-4 Phantom II
• Compatible aircraft: General Dynamics F-16 Fighting Falcon
• Compatible aircraft: Lockheed C-130 Hercules
• Recommended kit: Any / Universal
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS32-0411

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Detail sets. For matching projects, see Aircraft Model Kits and 1/32 Aircraft Model Kits.

FAQ

Why is this called the short length version?

The product name specifies a short length version. Compare the pod length and pylon position with your references and kit layout before final installation.

Do I need to modify the kit pylon to mount the pod?

Not always, but pylon interfaces differ by kit. Do a dry-fit first and only adjust contact points if the pod sits off-axis or leaves a visible gap.

Any workflow tips for Resin / 3D Printed parts?

Clean the part before paint, remove any supports carefully if present, and keep mating faces flat. Test-fit before paint, then attach after finishing to reduce handling.