AN/ALQ-71(V)-3 ECM pod (A-4, A-7, F-4, F-100, RF-101C, F-105) (1pcs) (3D Printed) Scale 1:32 ResKit RS32-0561

ResKit RS32-0561 provides an AN/ALQ-71(V)-3 ECM/Data Link pod for 1/32 aircraft builds, produced as a single-piece 3D printed part to keep the pod body geometry consistent and the panel breaks clean. This set is useful when you want sharper edges around access panels and a more defined nose/tail profile than many kit parts.

On the model, this pod typically sits under a pylon where alignment is very visible. A dedicated replacement helps keep the pod axis straight and makes it easier to maintain a tidy join line to the mounting point without over-sanding nearby surface detail.

For modelers: wash the part before priming, then do a quick dry-fit to your pylon and mark the exact attachment point. If you prefer a stronger joint, drill a small locating hole and add a short pin; this also helps keep the pod centered during glue cure.

Compatible aircraft

• A-4 Skyhawk,
• A-7 Corsair II,
• F-100 Super Sabre,
• F-105 Thunderchief,
• F-4 Phantom II

Product Specifications

• Subject: AN/ALQ-71(V)-3 ECM pod
• Scale: 1/32 (also written as 1:32)
• Product type: ECM/Data Link pod
• Type of equipment: Aircraft
• Recommended kit: Any / Universal
• Service / Subject country: USA
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS32-0561

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit ECM/Data Link pod or compare with ECM/Data Link pod (all brands). For matching builds, see Aircraft Model Kits and 1/32 Aircraft Model Kits.

FAQ

Will it fit any 1/32 kit?

It is listed as Any / Universal, but the exact pylon interface can be kit-dependent. Test-fit and adjust the mounting point to match your kit’s store station.

How should I prepare a 3D printed resin part before paint?

Wash with a mild degreaser, let it dry fully, then use a thin primer coat to check the surface before final paint.

What is the easiest way to keep the pod aligned under the wing?

Mark the centerline, dry-fit to the pylon, and consider a small pin for positive location so the pod stays straight while the adhesive cures.