AN / ALQ-87 ECM pods early type (2 pcs) (F-100, F-101, F-105, F-111, F-4) (3D Printing) Scale 1:32 ResKit RS32-0441 for Aircraft Model Kit

ResKit RS32-0441 is a resin / 3D printed AN/ALQ-87 ECM pods set in the early type configuration, supplied as 2 pcs for 1/32 aircraft builds. It is intended for cleaner pod geometry and crisper surface definition than many kit-supplied stores, especially along edges and seams that stay visible after paint.

This kind of external pod is easiest to notice on a finished model because it sits on the pylon line of sight, so straight alignment and consistent spacing matter for the overall look (fit remains kit-dependent).

For modelers: dry-fit the pod-to-pylon contact points before priming and check alignment from front and rear views. Remove supports in small steps if present, keep mating faces flat, then prime lightly so small surface detail stays readable.

Compatible aircraft

• North American F-100 Super Sabre
• McDonnell F-101 Voodoo
• Republic F-105 Thunderchief
• General Dynamics F-111 Aardvark
• McDonnell Douglas F-4 Phantom II

Product Specifications

• Subject: AN/ALQ-87 ECM pods (early type) (2 pcs)
• Scale: 1/32 (also written as 1:32)
• Product type: ECM/Data Link pod
• Type of equipment: Aircraft
• Recommended kit: Any / Universal
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS32-0441

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit ECM/Data Link pod. For matching builds, see Aircraft Model Kits and 1/32 Aircraft Model Kits.

FAQ

What is included in the set?

Two AN/ALQ-87 ECM pods in the early type configuration (2 pcs).

Will it fit any 1/32 kit out of the box?

Your data lists Any / Universal, but pylon contact nodes can differ by kit. Dry-fit first and adjust the mounting interface in small steps if needed.

Any tips for working with resin / 3D printed stores?

Remove supports gradually if present, clean only the contact points, and use a thin primer coat so fine surface detail stays sharp.

How do I keep pods aligned on the pylons?

Check the centerline from front and rear views during dry-fit. Make small adjustments before final glue so both pods sit parallel and at the same angle.