AN / ALQ-87 ECM pods early type (2 pcs) (F-100, F-101, F-105, F-111, F-4) (3D Printing) Scale 1:48 ResKit RS48-0441 for Aircraft Model Kit

ResKit RS48-0441 is a 1/48 AN / ALQ-87 ECM pods set (early type, 2 pcs) produced as 3D printed resin parts to add a clean, sharply defined pod option for classic USAF loadouts.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/48 scale aircraft models.

ECM pods are usually mounted on prominent pylons, so symmetry and a crisp pod profile matter for the overall stores layout. This set helps replace simplified kit pods and keeps both pods consistent as a pair, while pylon interfaces and station choices remain kit-dependent.

For modelers: decide the pylon station early and test-fit the pods before painting, then keep primer light to preserve edges and panel definition; if your kit includes separate sway braces, dry-fit them to confirm the pods sit straight and parallel.

Compatible aircraft

• North American F-100 Super Sabre
• McDonnell F-101 Voodoo
• Republic F-105 Thunderchief
• General Dynamics F-111 Aardvark
• McDonnell Douglas F-4 Phantom II

Product Specifications

• Subject: AN / ALQ-87 ECM pods early type (2 pcs)
• Variant / Family: ALQ-87 early type (kit-dependent)
• Scale: 1/48 (also written as 1:48)
• Product type: ECM/Data Link pod
• Type of equipment: Aircraft
• Recommended kit: Any / Universal
• Subject country: USA
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin, 3D Printed
• SKU: RS48-0441

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit ECM/Data Link pod or compare with ECM/Data Link pod (all brands). For matching builds, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Will these pods fit any 1/48 kit of the listed aircraft?

The set is intended as a universal 1/48 accessory, but pylons, sway braces and station geometry vary by kit. Test-fit and adjust the attachment method as needed (kit-dependent).

Where should I mount an ALQ-87 pod on my model?

Mounting positions depend on aircraft and configuration. Use your kit instructions and references for the specific loadout you are modeling, then test-fit to ensure the pod sits straight and clears sway braces (kit-dependent).

How do I keep both pods looking symmetrical?

Dry-fit the pair together and check they sit at the same angle and height before glue. Painting them as a matched pair helps keep the finish consistent.