Antonov An-225 Mrija, Detailing Engines, Scale 1:144 Resin, Photoetch (Recommended for kit: Revell) Metallic Details MD14429 - For aircraft model kits

Metallic Details MD14429 is an engines detailing set with resin and photo-etched parts for the Antonov An-225 Mrija in 1/144, recommended for the Revell kit.

The key benefit of an engine-focused upgrade in this scale is cleaner definition around intake and exhaust areas, plus more convincing depth on small engine features (exact content depends on the set parts).

The An-225 Mrija is a heavy cargo aircraft with a distinctive multi-engine layout. This set is intended to refine the engine presentation on your build without turning the project into a rework of the whole airframe.

For modelers: plan painting early: dry-fit the parts, then paint intake interiors and deeper engine areas before final assembly. Check alignment across all engines from front and side views, and use small glue amounts in stages to keep nacelles square and consistent.

• Subject: Antonov An-225 Mrija
• Variant / Family: An-225 Mrija (kit-dependent configuration)
• Scale: 1/144 (also written as 1:144)
• Product type: Detail Set
• Type of equipment: Aircraft
• Recommended kit: for Revell
• Service / Subject country: Ukraine (operator-dependent)
• Manufacturer: Metallic Details
• Country of manufacture: Ukraine
• Material: Resin parts, photo-etched metal
• SKU: MD14429

This item is part of Metallic Details and belongs to Aftermarket and Engines. For matching projects, browse 1/144 aircraft model kits, all Aircraft Model Kits, and Air Model Kits ALL.

FAQ

Should I paint the engine interiors before assembly?

Yes. Intake interiors and deeper engine areas are easier to paint before final assembly, then you can touch up seams and edges after dry-fitting and alignment checks.

Do I need to remove kit details to install the parts?

It depends on the kit areas being replaced. Test-fit first and remove only what interferes with seating, using light sanding and small trimming steps.

What glue works for resin and photo-etched parts?

CA is commonly used for resin and metal parts. Apply in small amounts and work in stages so you can correct alignment before it fully sets.