B-13L Rocket Launchers (2 pcs) (Su-17/22, Su-24, Su-25 ,MiG-23, MiG-29, Mi-8/24) (3D Printed) Scale 1:48 ResKit RS48-0529 for Helicopters / Aircraft Model Kit

ResKit RS48-0529 is a 1/48 weapons set of B-13L rocket launchers (2 pcs) produced as resin 3D printed parts. The set focuses on the tube openings and front face detail, so the launcher mouths look clean and evenly spaced without heavy cleanup.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/48 scale aircraft models.

Rocket pods are prominent on pylons and wing stations, and crisp tube definition helps them read correctly even after primer, paint, and a light wash.

For modelers: keep the front face protected while removing supports, then check alignment on the pylon before paint. If you plan to drill or deepen tube mouths, do it before priming and use a depth stop so both pods stay consistent.

Compatible aircraft

• Sukhoi Su-17/22 Fitter
• Sukhoi Su-24 Fencer
• Sukhoi Su-25 Frogfoot
• Mikoyan-Gurevich MiG-23 Flogger
• Mikoyan-Gurevich MiG-29 Fulcrum
• Mil Mi-8 Hip
• Mil Mi-24 Hind

Product Specifications

• Subject: B-13L rocket launchers (2 pcs)
• Scale: 1/48 (also written as 1:48)
• Product type: Weapons Set
• Type of equipment: Helicopters / Aircraft
• Recommended kit: Any / Universal (kit-dependent)
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS48-0529

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Arms and Weapons or compare with Arms and Weapons (all brands). For matching builds, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Will these fit any 1/48 kit?

The set is listed as Any / Universal, but pylon interfaces differ between kits. Dry-fit on your pylons and adjust the mounting surface if required (kit-dependent).

How do I keep the tube openings sharp during cleanup?

Remove supports from the rear or sides first and avoid sanding across the front face. If you need touch-up, use a fine round tool carefully and keep both pods matched.

Should I paint the pods before attaching them to pylons?

Do a full test-fit first, then paint separately for easier access to the front face and sides. Attach after painting once you know the contact areas sit flat.