BLU-1B (750 lb) napalm bombs finned MXU-469/B (4 pcs) (A-1, A-4, A-7, A-26K, B-57, F-100) (3D Printed) Scale 1:48 ResKit RS48-0598

ResKit RS48-0598 is a 3D printed set of BLU-1B (750 lb) napalm bombs with finned MXU-469/B units in 1/48, supplied as 4 pcs for aircraft model builds. The main benefit is the cleaner tail-fin geometry and smoother body surfaces, which helps these stores look consistent across a multi-bomb loadout.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/48 scale aircraft models.

This set is useful when your project features prominent underwing stores and you want the rack stations to read as evenly spaced, matching items rather than slightly different kit parts.

For modelers: keep the bombs on temporary holders for painting and handle them by the body, not the fins. Before final mounting, dry-fit to your pylons/racks and square the contact faces so all four sit at the same angle.

Compatible aircraft

• A-1 Skyraider,
• A-4 Skyhawk,
• A-7 Corsair II,
• B-26 (A-26) InvaderK,
• B-57 Canberra,
• F-100 Super Sabre

Product Specifications

• Subject: BLU-1B (750 lb) napalm bombs finned MXU-469/B (4 pcs)
• Scale: 1/48 (also written as 1:48)
• Product type: Weapons Set
• Type of equipment: Aircraft
• Recommended kit: Any / Universal
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS48-0598

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Arms and Weapons or compare with Arms and Weapons (all brands). For matching builds, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Is this set universal for any 1/48 kit?

It is listed as Any / Universal, but racks and mounting points are kit-dependent. Dry-fit first and adjust the contact faces or add small pins if you want stronger attachment.

How should I prep 3D printed resin parts before painting?

Wash parts to remove residue, let them dry fully, then apply a resin-safe primer. Keep sanding minimal around fin edges to preserve sharp geometry.

How can I keep all four stores aligned evenly?

Use the same seating depth on each rack station and check alignment from front and side views before the glue cures. A simple spacer helps keep spacing consistent.