British 1000lb HE-Blast, GP, Low Drag Bombs (4 pcs) (F-4, Canberra, Buccaneer, Harrier, Hunter, Tornado) (3D printed) Scale 1:48 ResKit RS48-0511 for Aircraft Model Kit

ResKit RS48-0511 Weapons Set includes four British 1000lb HE-Blast, GP, low drag bombs for 1/48 aircraft projects. The 3D printed parts focus on crisp fin edges and consistent tail geometry, helping your loadout look uniform across multiple stations.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/48 scale aircraft models.

This set is useful when you want to replace simplified kit stores and keep the external finish clean and symmetrical on classic jet builds where weapon alignment is very visible.

For modelers: treat these as small assemblies: clean support nubs first, then test-fit to your pylons and sway braces before paint. If you add decals or stencils from your spares, apply them after a gloss coat and seal with a thin clear layer to avoid silvering on curved bomb bodies.

Compatible aircraft

• McDonnell Douglas F-4 Phantom II
• Canberra
• Buccaneer
• Harrier
• Hunter
• Tornado

Product Specifications

• Subject: British 1000lb HE-Blast, GP, low drag bombs (4 pcs)
• Scale: 1/48 (also written as 1:48)
• Product type: Weapons Set
• Type of equipment: Aircraft
• Recommended kit: Any / Universal (kit-dependent)
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS48-0511

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Arms and Weapons or compare with Arms and Weapons (all brands). For matching builds, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Will these bombs fit any 1/48 kit of the listed aircraft?

They are supplied as an Any / Universal set, but pylon shapes and sway brace layouts vary by kit. Use a fit-check and adjust the mounting points to match your pylons.

How do I clean up 3D printed parts without damaging the fins?

Clip supports in stages and finish contact points with light sanding. Work on a flat surface and avoid twisting the fins while removing nubs.

What is a simple way to keep the loadout aligned across multiple stations?

Dry-fit all stations first, then mark a consistent fore-aft position on each pylon. If needed, drill shallow locating holes so every bomb sits at the same angle and spacing.

Should I prime before painting?

Yes. Wash the parts, let them dry, then apply a thin primer coat to improve paint grip and reveal any remaining cleanup marks.