BRU-41/A Improved Multiple Ejector Rack (IMER) (3 pcs) (F/A-18A/B/C/D) Scale 1:32 ResKit RS32-0364 for Aircraft Model Kit

ResKit RS32-0364 provides a BRU-41/A Improved Multiple Ejector Rack (IMER) set (3 pcs) for F/A-18A/B/C/D in 1/32. This type of rack is a focal point on the underside stations, so clean edges and straight alignment help the finished loadout look tidy after primer and paint.

The IMER layout is especially noticeable when you build with open pylons and visible mounting points, where small angle errors can stand out.

For modelers: dry-fit each rack to your kit pylon and check that all three sit at the same angle before painting. If parts include 3D printed supports, cut them away with a fine saw, sand attachment points lightly, then wash parts before priming.

Product Specifications

• Subject: BRU-41/A Improved Multiple Ejector Rack (IMER) (3 pcs) (F/A-18A/B/C/D)
• Scale: 1/32 (also written as 1:32)
• Product type: Pylons / Bomb Racks
• Type of equipment: Aircraft
• Recommended kit: Any / Universal
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS32-0364

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Pylons / Bomb Racks or compare with Pylons / Bomb Racks (all brands). For matching projects, see Aircraft Model Kits and 1/32 Aircraft Model Kits.

FAQ

What should I check first before painting these racks?

Dry-fit the rack to the kit pylon and confirm it sits square. Compare left/right stations so the angle and seating depth match before glue and paint.

How do I remove 3D printed supports without damaging edges?

Cut supports in small steps with a fine saw and finish with light sanding at the attachment points. Avoid heavy pressure so thin edges stay straight.

How can I keep alignment consistent across all three racks?

Mark the seating depth during a test-fit and use the same reference point on each pylon. Re-check on a flat surface before the glue fully cures.