CBU-89B Cluster Bombs GATOR (4 pcs) (A-10, F-15E, F-16, B-52, B-1B, B-2) (3D Printed) Scale 1:48 ResKit RS48-0523 for Aircraft Model Kit

ResKit RS48-0523 includes four CBU-89B Cluster Bombs GATOR for 1/48 aircraft builds. The 3D printed parts are consistent in diameter and end geometry, which helps when you want all four stores to look identical across a symmetrical pylon layout.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/48 scale aircraft models.

This set supports aircraft loadouts where the kit parts may be soft on small features or uneven between halves. As with most external stores, the exact mounting interface depends on your kit pylons, so final fit is kit-dependent.

For modelers: mark the pylon centerline and use it as a guide before gluing to keep all four bombs parallel. After removing supports, lightly sand contact points, wash the parts, and prime thinly to preserve sharp edges.

Compatible aircraft

• Fairchild Republic A-10 Thunderbolt II
• McDonnell Douglas F-15E Strike Eagle
• General Dynamics F-16 Fighting Falcon
• Boeing B-52 Stratofortress
• Rockwell B-1 Lancer
• Northrop B-2 Spirit

Product Specifications

• Subject: CBU-89B Cluster Bombs GATOR (4 pcs)
• Scale: 1/48 (also written as 1:48)
• Product type: Arms and Weapons
• Type of equipment: Aircraft
• Recommended kit: Any / Universal
• Subject country: USA
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS48-0523

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Arms and Weapons or compare with Arms and Weapons (all brands). For matching builds, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

What is the main fit consideration for this set?

Pylon spacing and attachment points vary by kit. Dry fit each store to confirm alignment and adjust the locating method if needed.

How do I keep a four-store loadout looking even?

Use a centerline reference on each pylon and compare the angle from the front and side before the glue sets. Small shims or pins can help keep everything parallel.

Do 3D printed parts need special prep?

Remove supports carefully, wash to remove residue, let dry fully, and apply a thin primer coat before painting.