Consolidated B-24 Liberator, Waist-gunners Cabin (for Revell/Monogram) Scale 1:48 Metallic Details MDR4881

Metallic Details MDR4881 is a mixed-media interior detail set for the Consolidated B-24 Liberator in 1/48, focused on the waist-gunners cabin. This area draws attention through the side openings, so consistent interior structure and correctly scaled gun parts can make the fuselage look more “occupied” without adding extra scratch work.

The set combines resin, photo-etched, and 3D-printed parts (including Browning M2 guns) for a concentrated upgrade of the waist section on the airframe.

The B-24 Liberator is a large multi-engine aircraft with side-position cabin areas that remain visible on many builds depending on how you finish the openings. This set is recommended for Revell and Monogram kits in the same scale.

For modelers: plan the waist-cabin work before closing the fuselage halves. Dry-fit the interior parts against both fuselage sides and check that the assembly does not interfere with the opening edges (kit-dependent). Prep resin and 3D-printed parts by washing before priming, and bend photo-etched parts gradually to avoid distortion. Paint the subassembly in stages, then install and re-check alignment before final closure.

• Subject: Consolidated B-24 Liberator
• Variant / Family: B-24 Liberator (waist-gunners cabin area)
• Scale: 1/48 (also written as 1:48)
• Product type: Detail set
• Type of equipment: Aircraft
• Recommended kit: for Revell, Monogram
• Service / Subject country: United States (subject origin)
• Manufacturer: Metallic Details
• Country of manufacture: Ukraine
• Material: Resin, photo-etched metal, 3D-printed parts
• SKU: MDR4881

This item is part of Metallic Details and belongs to Aftermarket and Interior Details. For matching projects, browse 1/48 aircraft model kits and all Aircraft Model Kits.

FAQ

Is this set compatible with both Revell and Monogram 1/48 B-24 kits?

It is recommended for Revell and Monogram. Fit can still vary by boxing and internal layout, so test-fit the cabin parts against both fuselage halves before committing.

Do I need special glue for the different materials?

Resin and 3D-printed parts are typically attached with CA glue. Photo-etched parts also usually require CA glue; apply small amounts and check alignment before it sets.

What is a practical build order for this area?

Assemble and paint the waist-cabin subassembly first, then dry-fit inside the fuselage and verify the opening edges stay clean. Install the gun parts near the end to reduce handling damage.