Control handles, Part 2 (for WWII-era German planes) Scale 1:32 Metallic Details MDR3211

Metallic Details MDR3211 is a 3D-printed control handle set for 1/32 aircraft cockpits. It focuses on small lever grips and console handles that add visual “busy-ness” to sidewalls and cockpit controls without rebuilding larger assemblies.

The set is intended for cockpit detailing of aircraft types listed by the manufacturer, where kit-molded handles can look soft or oversized at this scale.

Control handles are small parts, but they sit at eye level in an open cockpit and help define the look of throttle/console areas. Use them selectively to match your chosen cockpit layout rather than filling every panel with parts.

For modelers: decide placement before glue and mark mounting points first. If your kit has molded-on stubs, remove them cleanly and drill shallow locating holes so each handle sits square. Prime and paint the handles on the runner when possible, then install them after the main cockpit colors are finished to reduce touch-ups.

Product specifications

• Subject: Control handles for aircraft cockpits (Part 2)
• Variant / Family: Control handles series, Part 2 (aircraft types per manufacturer list)
• Scale: 1/32 (also written as 1:32)
• Product type: 3D printed set
• Type of equipment: Aircraft
• Recommended kit: for various compatible 1/32 aircraft model kits (kit-dependent)
• Service / Subject country: Germany (aircraft types listed by manufacturer)
• Manufacturer: Metallic Details
• Country of manufacture: Ukraine
• Material: Resin (3D-printed)
• SKU: MDR3211

This item is part of Metallic Details and belongs to Aftermarket and Interior Details. For compatible projects, browse 1/32 aircraft model kits and all Aircraft Model Kits.

FAQ

Which aircraft are these handles intended for?

The manufacturer lists use on Focke Wulf Fw 190, Messerschmitt Me 109, and Messerschmitt Me 262 cockpit detailing. Placement is kit-dependent, so compare with your cockpit layout before installation.

When should I add these parts during the build?

Install them after the main cockpit structure is assembled and painted, so you can set the correct angle and avoid damaging small parts during earlier handling.

How can I improve adhesion of very small resin parts?

Use clean mounting points, drill shallow locating holes where possible, and apply a minimal amount of CA with a fine applicator to keep surrounding detail crisp.

Historical model note: This item is intended for scale modeling and historical miniature building only. No political endorsement, propaganda, or discriminatory content is intended. Product images and markings should be checked before publication to ensure they do not show prohibited political symbols.