Curtiss F11C-2 Goshawk Scale 1:144 Metallic Details MDR14450

Metallic Details MDR14450 is a 1/144 Curtiss F11C-2 Goshawk aircraft model kit. The kit includes 3D-printed parts, photo-etched details, and decals, supporting a clean, thin-edged look on a compact biplane airframe.

The main value of this kit is in the fine structure: struts, small external fittings, and sharp outlines that can look overscale in 1/144 if simplified.

The Curtiss F11C-2 Goshawk is a single-engine biplane subject where wing alignment and strut geometry define the final appearance. Treat the build as a careful fit-and-square project rather than a “fast assembly” model.

For modelers: plan the wing-to-strut geometry early and dry-fit the biplane stack before committing to glue. A simple jig (foam block or stacked card) helps keep stagger and spacing consistent while joints cure. Keep photo-etched parts on the fret until needed, and add the most fragile pieces after main painting to reduce handling damage.

Product specifications

• Subject: Curtiss F11C-2 Goshawk
• Variant / Family: Curtiss F11C-2 Goshawk
• Scale: 1/144 (also written as 1:144)
• Product type: Aircraft Model Kit
• Type of equipment: Aircraft
• Recommended kit: Not applicable (this is a model kit)
• Manufacturer: Metallic Details
• Country of manufacture: Ukraine
• Material: Resin (3D-printed), photo-etched metal, decals
• SKU: MDR14450

This kit is part of Metallic Details and belongs to Aircraft Model Kits. For the same format, see 1/144 aircraft model kits, plus matching Aftermarket and Decals.

FAQ

Does the kit include decals?

Yes. Decals are included for the Curtiss F11C-2 Goshawk build.

Any practical tips for keeping the biplane wings aligned in 1/144?

Use a simple jig to hold the lower wing, fuselage, and upper wing at a fixed spacing while the struts set. Re-check alignment from front and side views before the glue cures.

How should I handle small photo-etched parts at this scale?

Remove parts only when needed, bend with smooth flat tools, and attach with minimal CA. Test-fit first, and add them after main painting to keep edges clean.