Dassault Mirage 2000B Cockpit (Basic edition with 3D Decals) for Kinetic kit (3D Printed) Scale 1:48 ResKit RSU48-0374 for Aircraft Model Kit

ResKit RSU48-0374 is a 3D printed cockpit set for the Dassault Mirage 2000B in 1/48, made to update the visible cockpit area in Kinetic builds with sharper part geometry and cleaner instrument presentation.

Aftermarket accessory intended for aircraft scale model kits and miniature replicas, focused on cockpit detailing rather than kit-wide changes.

Precision parts for accurate 1/48 scale aircraft model builds, with a workflow that suits careful dry-fitting and staged painting before final assembly.

This cockpit set helps when you want more defined surfaces around the instrument panel, side consoles, and other high-visibility areas under the canopy, without turning the build into a complicated rework of the entire fuselage.

For modelers: dry-fit each sub-assembly early and remove any remaining print supports before paint. Wash parts to improve primer grip, and apply 3D decals over a smooth glossy base so they seat cleanly on the panel faces.

Product Specifications

• Subject: Dassault Mirage 2000B
• Scale: 1/48 (also written as 1:48)
• Product type: 3D Printed Set
• Type of equipment: Aircraft
• Recommended kit: for Kinetic
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin
• SKU: RSU48-0374

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Cockpit & Cargo Bay or compare with Cockpit & Cargo Bay (all brands). For matching builds, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Is this set specific to the Mirage 2000B variant?

It is labeled for the Dassault Mirage 2000B. If your project uses a different Mirage 2000 variant, compare cockpit layout and kit parts first, as details can be variant-dependent.

Do I need special steps before painting?

Yes. Clean the resin parts to remove any residue, then prime lightly. Test-fit before paint where possible, since small adjustments are easier to do on bare resin.

How should I apply the 3D decals in the cockpit?

Place them on a smooth glossy surface for better contact, then seal with a compatible clear coat once fully set. Work in small sections to keep alignment tidy.

What glue works best for assembly?

Use a small amount of cyanoacrylate (CA) or another resin-safe adhesive, and avoid flooding joints near fine cockpit detail.