Emerson Electric TAT-102 Turret for the helicopter model AH-1G Cobra (for AH-1G ICM, Special Hobby and Revell kits) Scale 1:32 Metallic Details MDR3217

Metallic Details MDR3217 is a 3D-printed exterior detail set for the Emerson Electric TAT-102 turret on the AH-1G Cobra in 1/32. This area sits at the front of the airframe, so sharper geometry and cleaner edges help the model look more convincing even under a closed canopy and minimal weathering.

This is an upgrade set only (the helicopter model kit is not included). The set is recommended for ICM 1/32 AH-1G builds; compatibility with other 1/32 AH-1G toolings can be project-dependent.

The turret section is a focal point on the AH-1G, and small alignment errors are easy to notice from head-on angles. Treat this upgrade as a “centerline” task: keeping the assembly straight and centered improves the overall look of the nose area.

For modelers: test-fit the turret parts against the kit fuselage before paint and mark the centerline. Clean support contact points carefully to preserve edges, then prime to unify the resin surface. Install after major seam work on the fuselage is finished, and re-check clearance/positioning before final glue sets.

• Subject: Emerson Electric TAT-102 turret for AH-1G Cobra
• Variant / Family: AH-1G Cobra family (fit kit-dependent)
• Scale: 1/32 (also written as 1:32)
• Product type: 3D Printed Set
• Type of equipment: Helicopter
• Recommended kit: for ICM (other compatible 1/32 AH-1G kits, fit check recommended)
• Manufacturer: Metallic Details
• Country of manufacture: Ukraine
• Material: 3D-printed resin
• SKU: MDR3217

This item is part of Metallic Details and belongs to Aftermarket and Exterior Details. For compatible projects, browse Helicopter Model Kits and 1/32 helicopter model kits.

FAQ

Is this set made specifically for ICM 1/32 AH-1G?

It is listed as recommended for ICM. If you use another 1/32 AH-1G kit, compare the kit nose opening and test-fit before committing to glue.

When should I install the turret parts?

Install after the main fuselage seams are finished and the nose area is stable. This helps avoid damage during sanding and repeated handling.

What should I check during dry-fit?

Check centering on the fuselage centerline and confirm the turret sits square in front view. Re-check clearance and alignment before the adhesive fully cures.