F-35 A Lightning II, Landing Gears, Wheels (Meng Model) (for Meng Model) Scale 1:48 Metallic Details MDR48246

Metallic Details MDR48246 is a resin / 3D-printed upgrade set for 1/48 builds of the F-35A Lightning II, recommended for Meng Model kits. It focuses on the landing gear area, providing replacement parts to refine the look of gear legs and wheels where small shapes and edges can benefit from sharper definition.

On modern aircraft builds, the landing gear is a high-contrast detail area against a clean underside finish, and wheel/strut geometry is easy to compare side-to-side. This set helps you keep the gear assembly consistent and more scale-like without changing the overall build approach.

For modelers: dry-fit the gear legs into their mounting points early and check the sit and toe-in before paint. Paint wheels and struts as subassemblies, then add any delicate parts late to avoid breakage. If you use washes, apply them after a clear coat so the detail remains crisp rather than stained.

• Subject: F-35A Lightning II
• Variant / Family: F-35A (CTOL) (kit-dependent)
• Scale: 1/48 (also written as 1:48)
• Product type: Landing Gear Set
• Type of equipment: Aircraft
• Recommended kit: for Meng Model
• Service / Subject country: operator-dependent
• Manufacturer: Metallic Details
• Country of manufacture: Ukraine
• Material: Resin, 3D-printed parts
• SKU: MDR48246

This item is part of Metallic Details and belongs to Aftermarket. Related upgrade categories include Landing Gear and Wheels. For matching projects, browse 1/48 aircraft model kits and all Aircraft Model Kits.

FAQ

Does this set replace the full landing gear assembly?

It is listed for detailing landing gears and wheels. Compare the parts provided with your kit instructions to plan which steps change and which remain kit parts.

How do I keep the aircraft stance even?

Test-fit all three gear legs and wheels on a flat surface before final glue. Adjust alignment while the joints are still workable so the model sits level.

What glue is recommended for resin and 3D-printed parts?

Most builders use cyanoacrylate (CA) for resin/3D-printed parts. Lightly sand mating surfaces and dry-fit first to improve contact and alignment.