FAB-250 M-54 bombs (4 pcs) (MiG-21/23/27/29, Su-7/17/20/22/24/25/27/30/ YAK-130) (3D Printed) Scale 1:48 ResKit RS48-0565

ResKit RS48-0565 is a 3D printed set of FAB-250 M-54 bombs in 1/48, supplied as 4 pcs for aircraft loadouts. The main visual benefit is consistent body taper and tail detail across all four bombs, which helps a multi-store setup look uniform rather than mixed from slightly different kit parts.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/48 scale aircraft models.

Bomb shapes are simple at first glance, but small differences in tail units and clean cylindrical surfaces are easy to spot under the wing. This set is intended to improve the look of a classic-style external store fit while keeping final attachment and rack choice dependent on your specific kit (kit-dependent).

For modelers: after washing and drying, remove supports in stages and keep sanding localized to contact points to preserve roundness. If you are mounting multiple bombs on one rack, make a quick spacing guide (card strip or ruler marks) so all four sit at the same depth and angle before glue sets.

Compatible aircraft

• MiG-21 Fagot,
• MiG-27 Flogger
• MiG-27 Flogger
• MiG-29 Fulcrum,
• Su-7 Fitter-A,
• Su-17/22 Fitter,
• Su-24 Fencer,
• Su-25 Frogfoot
• Su-27 Flanker,
• YAK-130

Product Specifications

• Subject: FAB-250 M-54 bombs (4 pcs)
• Scale: 1/48 (also written as 1:48)
• Product type: Weapons Set
• Type of equipment: Aircraft
• Recommended kit: Any / Universal - for compatible 1/48 kits (kit-dependent)
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS48-0565

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Arms and Weapons or compare with Arms and Weapons (all brands). For matching builds, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Will these bombs fit any 1/48 kit?

They are listed as Any / Universal, but pylons, racks, and mounting lugs vary by kit. Dry-fit first and adapt the attachment method to your rack or pylon (kit-dependent).

How can I keep all four bombs looking consistent?

Prime in thin coats and check the surface for flat spots after support cleanup. Use the same mounting depth and angle for all four bombs so the set reads as a matched loadout.

What is a safe workflow for 3D printed round parts?

Wash and dry the parts, remove supports gradually, and sand with light pressure. Keep cleanup limited to support marks to preserve the cylinder shape and tail edges.