GBU-10 Paveway I laser guided bombs with BSU-37/B fin and BSU-3A/B wing (slow speed) thermally protected (2 pcs) (F-4D/E, F-111, A-6A, A-7E) (3D Printed) Scale 1:48 ResKit RS48-0576

ResKit RS48-0576 Weapons Set includes two GBU-10 Paveway I laser guided bombs with BSU-37/B fin and BSU-3A/B wing (slow speed) as 3D printed parts for 1/48 aircraft builds. This set is focused on the distinctive guidance and tail/wing shapes, so the overall silhouette reads correctly even before you add paint and markings.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/48 scale aircraft models.

It is a useful replacement when your kit provides generic stores, or when you want a matched pair with consistent fin angles and wing thickness for a clean, symmetrical loadout.

For modelers: keep the guidance sections protected during cleanup. Remove supports first, then test-fit the bombs to your pylons and check clearance around adjacent stores. If your kit uses different lug spacing, drill shallow locating holes and add short pins so both bombs sit parallel.

Product Specifications

• Subject: GBU-10 Paveway I laser guided bombs with BSU-37/B fin and BSU-3A/B wing (slow speed), thermally protected (2 pcs)
• Scale: 1/48 (also written as 1:48)
• Product type: Weapons Set
• Type of equipment: Aircraft
• Recommended kit: Any / Universal (kit-dependent)
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS48-0576

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Arms and Weapons or compare with Arms and Weapons (all brands). For matching builds, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Why is there no Compatible aircraft list for multiple types?

The provided aircraft list here contains only one item, so it is kept as part of the general description and specifications rather than a separate Compatible aircraft block.

Will these bombs fit any 1/48 kit?

They are listed as Any / Universal, but pylons and attachment points vary by kit. Use a dry-fit and adapt the mounting to your specific kit and station layout.

How should I clean up 3D printed wings and fins?

Remove supports in small steps and sand contact points lightly. Prime with a thin coat after washing to reveal any remaining marks while keeping edges sharp.

What is a simple way to keep both bombs aligned the same?

Dry-fit both stations first and mark a consistent fore-aft position on each pylon. If needed, add shallow locating holes and short pins so both bombs sit parallel.