GBU-10 Paveway I laser guided bombs with BSU-4/B fin and BSU-3/B wing (2 pcs) (F-4D/E, F-111, A-6A, A-7E) (3D Printed) Scale 1:48 ResKit RS48-0521

ResKit RS48-0521 is a 1/48 weapons set of GBU-10 Paveway I laser guided bombs (2 pcs) with BSU-4/B fin and BSU-3/B wing. Resin 3D printed production helps keep the wing and fin geometry crisp, so the guidance surfaces read cleanly once painted.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/48 scale aircraft models.

This configuration is visually defined by the wing and tail unit, making it a good choice when you want your stores to look sharper than typical kit parts on an aircraft loadout.

For modelers: before primer, lightly scrape along the wing edges to remove any remaining support nubs, then sand with a rigid block to keep the airfoil lines straight. Do a rack/pylon test-fit early because attachment points can be kit-dependent.

Product Specifications

• Subject: GBU-10 Paveway I laser guided bombs with BSU-4/B fin and BSU-3/B wing (2 pcs)
• Scale: 1/48 (also written as 1:48)
• Product type: Weapons Set
• Type of equipment: Aircraft
• Recommended kit: Any / Universal (kit-dependent)
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS48-0521

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Arms and Weapons or compare with Arms and Weapons (all brands). For matching builds, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Is this set only for the aircraft listed in the title?

The set is listed as Any / Universal in 1/48, but pylons and racks vary by kit. Use the title list as common applications and confirm your kit stores layout during test-fit.

How should I handle the BSU-3/B wing and tail unit during cleanup?

Support the parts close to the attachment point while cutting, and sand contact areas with a small flat block to keep edges straight. Avoid twisting the wing surfaces.

What is a practical prep order before painting?

Wash the parts, remove supports, then do a full dry-fit to racks/pylons. Prime lightly to preserve surface definition, then paint and weather before final attachment.