GBU-31 (V) 1/B Bombs U,S, Air Force (2 pcs) (A-10, B-1, B-2, B-52, F-15E, F-16C/D, F-35, F-22, P-3, F-117) (3D Printed) Scale 1:48 ResKit RS48-0119 for Aircraft Model Kit

ResKit RS48-0119 includes GBU-31 (V) 1/B bombs in 1/48 as a 2-piece 3D printed set for aircraft external stores. The parts are aimed at clean geometry and sharp fin/edge definition, helping the tail unit and body proportions look consistent once mounted under pylons.

This set is useful for modern aircraft builds where the store shapes are prominent and you want a matched pair with uniform surface detail instead of simplified kit weapons.

For modelers: dry-fit the bombs to your rack or pylon first and confirm sway-brace clearance (kit-dependent). Remove supports in small steps and check fin alignment from the rear; a thin primer coat helps spot contact marks before final paint.

Compatible aircraft

• Fairchild Republic A-10 Thunderbolt II
• Rockwell B-1 Lancer
• Northrop B-2 Spirit
• Boeing B-52 Stratofortress
• General Dynamics F-16 Fighting Falcon
• McDonnell Douglas F-15 Eagle/Strike Eagle
• Lockheed Martin F-35 Lightning II

Product Specifications

• Subject: GBU-31 (V) 1/B Bombs U,S, Air Force (2 pcs)
• Scale: 1/48 (also written as 1:48)
• Product type: Weapons Set
• Type of equipment: Aircraft
• Recommended kit: Any / Universal
• Service / Subject country: USA
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS48-0119

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Arms and Weapons or compare with Arms and Weapons (all brands). For matching projects, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Is this set kit-specific?

The set is listed as Any / Universal, but fit can be kit-dependent because racks, pylons, and mounting points vary between kit manufacturers.

Any tips for mounting a matched pair evenly?

Dry-fit both bombs together and check they sit parallel and at the same height. Make small adjustments at the rack interface only where needed.

How should I prepare 3D printed weapons before painting?

Remove supports gradually and smooth contact points with fine sanding. A thin primer coat helps reveal any remaining marks before final paint.