Grumman F-14D Tomcat Air Intakes for Tamiya kit (3D Printed) Scale 1:48 ResKit RSU48-0379 for Aircraft Model Kit

ResKit RSU48-0379 provides replacement air intakes for the F-14D Tomcat in 1/48, designed to improve the internal intake trunk geometry and smoother transition from intake lip to duct interior.

Resin/3D printed aftermarket accessory for aircraft scale model kits, created to refine intake depth and internal surface continuity on detailed builds.

Detailed parts for realistic 1/48 scale aircraft model builds, helping reduce visible seams and improving the visual depth inside the intake trunks (kit-dependent).

The F-14’s intake system is a noticeable feature on the aircraft, and refined trunking helps the front fuselage area appear more consistent when viewed from shallow angles.

For modelers: test-fit the intake trunks with the fuselage halves before painting. Light sanding along the mating edges can improve alignment, and painting the inner ducts before final assembly helps maintain clean internal surfaces.

Compatible aircraft

• Grumman F-14 Tomcat

Product Specifications

• Subject: Grumman F-14D Tomcat
• Scale: 1/48 (also written as 1:48)
• Product type: Air Intakes
• Type of equipment: Aircraft
• Recommended kit: for Tamiya
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin
• SKU: RSU48-0379

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Air Intakes or compare with Air Intakes (all brands). For matching builds, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Are these air intakes designed specifically for the Tamiya kit?

Yes, the set is intended for the Tamiya 1/48 F-14 kit. Fit with other manufacturers may vary and should be confirmed with careful dry-fitting.

Should the intake trunks be painted before installation?

Painting the intake interior before final assembly helps maintain a clean finish and avoids difficult masking later in the build.

Do the resin parts require preparation before use?

Yes. Wash the parts in mild soapy water to remove residue, then remove any remaining support marks and lightly sand the mating surfaces.