Mark 77 napalm bombs Mod. 2 (2pcs) (A-4, A-26K, F-4, AV-8B, F/A-18) (3D Printed) Scale 1:48 ResKit RS48-0603

ResKit RS48-0603 is a 3D printed set of Mark 77 napalm bombs Mod. 2 in 1/48, supplied as 2 pcs for aircraft loadouts. The key visual upgrade is the clean tank-like shape with sharper seams and more consistent tail detail, helping the pair look uniform when mounted side-by-side.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/48 scale aircraft models.

Large external stores sit in a very visible position under the wing, so straight mounting and tidy surfaces matter on a finished model. This set is intended to refine the look of the stores while keeping the final attachment method flexible across different pylons and racks (kit-dependent).

For modelers: plan the mounting before paint: dry-fit to your rack/pylon, mark the contact points, then add a small pin for a stronger joint. Remove supports in stages and keep sanding localized so the cylindrical profile stays round and edges remain crisp under primer.

Compatible aircraft

• A-4 Skyhawk,
• B-26 (A-26) InvaderK,
• F-4 Phantom II
• AV-8B Harrier II,
• F/A-18 Hornet/Super Hornet

Product Specifications

• Subject: Mark 77 napalm bombs Mod. 2 (2 pcs)
• Scale: 1/48 (also written as 1:48)
• Product type: Weapons Set
• Type of equipment: Aircraft
• Recommended kit: Any / Universal - for compatible 1/48 kits (kit-dependent)
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS48-0603

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Arms and Weapons or compare with Arms and Weapons (all brands). For matching builds, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Will this set fit any 1/48 kit?

It is listed as Any / Universal, but racks, pylons, and locating points vary by kit. Dry-fit first and adapt the mounting method to your kit setup (kit-dependent).

How should I prepare 3D printed stores before painting?

Wash and dry the parts, remove supports carefully, then prime in thin coats. Keep cleanup focused on support marks so surface lines and edges stay sharp.

What helps keep a matched pair aligned evenly?

Use the same mounting depth and angle on both sides and check alignment from front and rear views. Pinning each store to the rack can help lock spacing during final assembly.