MBD2-67U multiple bombs racks (2 pcs) (MiG-21, MiG-23, MiG-27(M), MiG-29, Su-25, Su-24, Yak-38) (3D Printed) Scale 1:32 ResKit RS32-0557

ResKit RS32-0557 is a 3D printed 1/32 set of MBD2-67U multiple bombs racks (2 pcs) for aircraft models. It is meant to give you cleaner rack geometry and sharper edges than many kit parts, which becomes noticeable once you hang multiple small stores under the same station.

These racks are useful when your build needs consistent spacing and alignment for a multi-store setup, where even a slight twist can make the loadout look uneven. Because pylon interfaces and mounting points differ between kits, final fit should be treated as kit-dependent.

For modelers: dry-fit the rack to the pylon first, then test a representative store to confirm clearance and straight alignment before committing to glue. Remove supports gradually and true the mating faces so both racks sit at the same angle on the airframe.

Compatible aircraft

• MiG-21 Fagot,
• MiG-27 Flogger
• MiG-27 Flogger
• MiG-29 Fulcrum,
• Su-25 Frogfoot
• Su-24 Fencer,
• Yak-38 Forger

Product Specifications

• Subject: MBD2-67U multiple bombs racks (2 pcs)
• Scale: 1/32 (also written as 1:32)
• Product type: Pylons / Bomb Racks
• Type of equipment: Aircraft
• Recommended kit: Any / Universal (kit-dependent pylons and mounting)
• Service / Subject country: Ukraine/USSR
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS32-0557

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Pylons / Bomb Racks or compare with Pylons / Bomb Racks (all brands). For matching builds, see Aircraft Model Kits and 1/32 Aircraft Model Kits.

FAQ

Will these racks fit any 1/32 kit?

The set is Any / Universal, but mounting points and pylon shapes vary by kit. Dry-fit to your pylons and adjust only the contact surfaces needed for a straight, stable fit.

How do I keep both racks aligned the same way?

Use one rack as the reference: mark its position on the pylon, then repeat the same placement for the second. A simple jig or spacer can help keep angles consistent while glue cures.

Any tips for cleaning 3D printed rack parts?

Remove supports in small steps and smooth attachment points with fine abrasives. Prime early to reveal any remaining marks before final paint.