MBD2-67U multiple bombs racks (2 pcs) (MiG-21, MiG-23, MiG-27(M), MiG-29, Su-25, Su-24, Yak-38) (3D Printed) Scale 1:48 ResKit RS48-0557

ResKit RS48-0557 is a 3D printed set of MBD2-67U multiple bombs racks in 1/48, supplied as 2 pcs for aircraft loadouts. The key visual upgrade is the rack structure itself: clean edges, consistent spacing, and sharper small shapes that keep the rack looking like a separate assembly rather than a simplified lump under the wing.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/48 scale aircraft models.

Multi-bomb racks sit in a very visible area and often define the whole underside look of a build. This set is intended to support a more convincing pylon/rack presentation while leaving final fit and store choice up to the specific kit and project (kit-dependent).

For modelers: test-fit the racks to the kit pylon/wing station early and check symmetry side-to-side before paint. After support removal, lightly sand only the contact faces; for a stronger joint, drill a small locating hole and add a short wire pin so the rack stays square during handling.

Compatible aircraft

• MiG-21 Fagot,
• MiG-27 Flogger
• MiG-27 Flogger
• MiG-29 Fulcrum,
• Su-25 Frogfoot
• Su-24 Fencer,
• Yak-38 Forger

Product Specifications

• Subject: MBD2-67U multiple bombs racks (2 pcs)
• Scale: 1/48 (also written as 1:48)
• Product type: Pylons / Bomb Racks
• Type of equipment: Aircraft
• Recommended kit: Any / Universal - for compatible 1/48 kits (kit-dependent)
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS48-0557

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Pylons / Bomb Racks or compare with Pylons / Bomb Racks (all brands). For matching builds, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Why is the set listed as Any / Universal?

The racks are listed as Any / Universal because different kits represent pylons and mounting points differently. Dry-fit first and adapt the attachment method to your kit (kit-dependent).

How do I keep two racks aligned the same way?

Set both racks to the same mounting depth and angle before glue sets. A small pin hole and wire pin can help keep the rack square and prevent twist.

How should I prep 3D printed racks for paint?

Wash and dry the parts, remove supports carefully, then prime lightly. Keep cleanup focused on support marks so you do not soften the rack edges and small details.