McDonnell Douglas F-15 (E,I,K) Strike Eagle Wheels set Scale 1:72 ResKit RS72-0021 for Aircraft Model Kit

ResKit RS72-0021 is a 3D printed resin wheels set for 1/72 McDonnell Douglas F-15 Eagle/Strike Eagle builds, covering (E, I, K) variants. The key benefit is cleaner wheel hub detail and more defined tire sidewalls, which improves the look of the heavy-duty landing gear in a small scale.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/72 scale aircraft models.

This set helps on F-15 builds where the stance and main gear area are very visible, especially if the kit wheels have shallow hub detail or a soft rim edge after paint.

For modelers: dry-fit wheels on the gear legs early and ensure both mains touch a flat surface evenly. After priming, paint hubs and tires separately, then re-check alignment before final glue so the aircraft sits square.

Product Specifications

• Subject: McDonnell Douglas F-15 Eagle/Strike Eagle wheels (E, I, K)
• Scale: 1/72 (also written as 1:72)
• Product type: Wheels Set
• Type of equipment: Aircraft
• Recommended kit: Any / Universal - for compatible 1/72 F-15 kits (kit-dependent)
• Service / Subject country: USA
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS72-0021

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Wheels or compare with Wheels (all brands). For matching builds, see Aircraft Model Kits and 1/72 Aircraft Model Kits.

FAQ

Will these wheels fit any 1/72 F-15 kit?

The set is listed as Any / Universal, but axle diameter and gear leg geometry vary by kit. Dry-fit first and adjust the mounting hole if required (kit-dependent).

How can I avoid a crooked stance on the finished model?

Test-fit both main wheels on the gear legs and check the model on a flat surface before final glue. Let the glue set with the aircraft supported level so both mains stay even.

Do 3D printed resin wheels need special prep before paint?

Remove supports carefully, wash the parts, and prime lightly. A thin primer coat helps keep hub detail crisp in 1/72.