Mk.82 Bombs (6 pcs) (F-4, F-5, F-8, F-15, F-16, F-18, A-1, A-4, A-6, A-7, A-10, Kfir) (3D Printed) Scale 1:72 ResKit RS72-0342

ResKit RS72-0342 is a 3D printed resin Weapons Set featuring Mk.82 bombs (6 pcs) for 1/72 aircraft builds. The set focuses on clean body proportions and sharp tail fin detail, helping external stores remain well-defined even after primer and paint.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/72 scale aircraft models.

General-purpose bombs are often mounted in multiple positions under the wings or fuselage. A consistent six-piece set allows symmetrical load configurations and improves visual coherence when kit-supplied parts appear simplified.

For modelers: carefully remove supports around the tail fins and test-fit each bomb to your pylons before painting. Install in mirrored pairs and check spacing from front and top views to maintain alignment across stations (kit-dependent).

Compatible aircraft

• McDonnell Douglas F-4 Phantom II
• North American F-100 Super Sabre
• Northrop F-5 Freedom Fighter/Tiger II
• Republic F-105 Thunderchief
• General Dynamics F-16 Fighting Falcon
• F/A-18 Hornet/Super Hornet
• Douglas A-1 Skyraider
• Douglas A-4 Skyhawk
• Grumman A-6 Intruder
• Grumman EA-6 Prowler
• LTV A-7 Corsair II
• Fairchild Republic A-10 Thunderbolt II
• IAI Kfir
• Harrier

Product Specifications

• Subject: Mk.82 bombs
• Scale: 1/72 (also written as 1:72)
• Product type: Weapons Set
• Type of equipment: Aircraft
• Recommended kit: Any / Universal - for compatible 1/72 kits (kit-dependent)
• Service / Subject country: USA
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS72-0342

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Arms and Weapons or compare with Arms and Weapons (all brands). For matching builds, see Aircraft Model Kits and 1/72 Aircraft Model Kits.

FAQ

Will these bombs fit all listed aircraft kits?

The set is labeled Any / Universal, but pylon spacing and rack design vary between brands. Always dry-fit before final installation (kit-dependent).

How should I arrange a six-bomb load?

Install bombs in mirrored pairs and verify spacing from multiple angles while the adhesive cures to maintain a balanced configuration.

Do 3D printed bombs need special preparation?

Remove supports carefully, wash the parts, and apply a thin primer coat to preserve fine fin and surface detail in 1/72.