Mk.83 Bombs with MAU-91 Thermally Protected (4 pcs) (A-4(C,E,F,L,M), TA-4F/J, A-6, A-7E, F-4(J,N,S), P-3, S-3, F/A-18(A,B,C,D)) (3D printed) Scale 1:48 ResKit RS48-0498 for Aircraft Model Kit

ResKit RS48-0498 is a 1/48 Mk.83 bombs with MAU-91 thermally protected weapons set (4 pcs) made as 3D printed resin parts, focusing on consistent bomb body geometry and clean tail-unit detail for U.S. Navy style stores layouts.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/48 scale aircraft models.

When four identical stores are carried together, symmetry becomes a major part of the model’s look. This set helps keep fin shapes and body alignment consistent across the full loadout, while pylon interfaces, sway braces and station spacing depend on the kit (kit-dependent).

For modelers: dry-fit all four bombs with your pylons and sway braces before painting to confirm spacing and clearance, then remove supports in small steps to protect tail detail; paint and seal the bomb bodies first, and add small details after a clear coat to reduce handling marks.

Compatible aircraft

• Douglas A-4 Skyhawk
• Grumman A-6 Intruder
• LTV A-7 Corsair II
• McDonnell Douglas F-4 Phantom II
• Lockheed P-3 Orion
• Lockheed S-3 Viking
• F/A-18 Hornet/Super Hornet

Product Specifications

• Subject: Mk.83 Bombs with MAU-91 Thermally Protected (4 pcs)
• Scale: 1/48 (also written as 1:48)
• Product type: Weapons Set
• Type of equipment: Aircraft
• Recommended kit: Any / Universal
• Subject country: USA
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin, 3D Printed
• SKU: RS48-0498

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Arms and Weapons or compare with Arms and Weapons (all brands). For matching builds, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Will these bombs fit any 1/48 kit of the listed aircraft?

The set is intended as a universal 1/48 accessory, but pylons, sway braces and station geometry vary by kit manufacturer. Test-fit and adjust the attachment method as needed (kit-dependent).

How do I keep four bombs aligned as a matched loadout?

Dry-fit the full set and check that each bomb sits parallel and at the same height before glue. Small alignment tweaks are easier before paint and final assembly.

How should I remove supports without damaging tail detail?

Cut supports gradually and avoid twisting the tail section. A thin primer coat helps reveal remaining marks so you can correct them with minimal sanding.