Multi weapon Inboard Pylons for Republic F-105 Thunderchief (2 pcs) (3D Printing) Scale 1:48 ResKit RS48-0425 for Aircraft Model Kit

ResKit RS48-0425 is a 1/48 multi weapon inboard pylons set for Republic F-105 Thunderchief, supplied as 2 pieces in 3D printed resin. The pylons are a high-visibility detail on the F-105, and a crisp, straight pylon profile helps the underside look more structured, especially when you plan a busy loadout.

Inboard pylons influence both the silhouette and how “clean” the stores stations look. A dedicated replacement can help if the kit pylons have rounded edges, simplified sway brace areas, or soft detail where the pylon meets the wing.

For modelers: dry-fit each pylon to the wing and verify left/right symmetry before painting. Prime lightly to preserve edges, paint pylons separately from stores, and install using a simple alignment reference so both pylons sit at the same angle and distance from the wing.

Product Specifications

• Subject: Multi weapon inboard pylons for Republic F-105 Thunderchief (2 pcs)
• Scale: 1/48 (also written as 1:48)
• Product type: Pylons / Bomb Racks
• Type of equipment: Aircraft
• Recommended kit: Any / Universal
• Service / Subject country: USA
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS48-0425

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Pylons / Bomb Racks or compare with Pylons / Bomb Racks (all brands). For matching builds, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Will these inboard pylons fit any 1/48 F-105 kit?

The set is listed as Any / Universal, but the wing interface can be kit-dependent. Dry-fit to your kit wing surface and adjust the contact area as needed.

What is a clean workflow for pylons and stores?

Paint pylons and stores separately, install pylons first, then add stores after the pylon alignment is fixed. This helps keep spacing and angles consistent.

How should I prepare 3D printed resin pylons before painting?

Wash the parts, allow them to dry fully, and apply a thin primer coat. This improves paint adhesion while keeping edges sharp.