NAVY Inboard Pylons for McDonnell Douglas F-4 Phantom II (2 pcs) (F-4B, F-4J, F-4N, F-4S, RF-4B) (3D Printed) Scale 1:48 ResKit RS48-0447 for Aircraft Model Kit

ResKit RS48-0447 is a 1/48 set of NAVY inboard pylons for the McDonnell Douglas F-4 Phantom II (2 pcs), made as resin/3D printed parts. This set is aimed at cleaner pylon geometry and sharper mounting detail, helping underwing stores sit straighter and look more consistent in underside views.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/48 scale aircraft models.

Inboard pylons are highly visible on Phantom builds because they define spacing and angle for tanks, racks, and other stores. Replacing simplified kit pylons helps reduce uneven left/right alignment once everything is mounted.

For modelers: dry-fit each pylon to the wing and confirm the toe-in/out angle before glue, then test the planned stores for clearance. Lightly true the mating surfaces if needed and align both pylons side-by-side to keep height and angle matching; final fit can be kit-dependent.

Compatible aircraft

• F-4B
• F-4J
• F-4N
• F-4S
• RF-4B

Product Specifications

• Subject: NAVY Inboard Pylons for McDonnell Douglas F-4 Phantom II (2 pcs)
• Variant / Family: F-4 Phantom II family (NAVY variants listed above)
• Scale: 1/48 (also written as 1:48)
• Product type: Pylons / Bomb Racks
• Type of equipment: Aircraft
• Recommended kit: Any / Universal
• Service / Subject country: USA
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS48-0447

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Pylons / Bomb Racks or compare with Pylons / Bomb Racks (all brands). For matching builds, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

What is included in the set?

The package contains two inboard pylons as unpainted, unassembled parts.

Will these fit any 1/48 F-4 kit?

The set is intended for 1/48 F-4 NAVY variants listed above, but wing interfaces can vary by kit, so final fit and angle can be kit-dependent.

Any tip for keeping left and right pylons aligned?

Dry-fit both pylons at the same time, measure their position from the same reference point on each wing, and check symmetry from front and underside views before glue cures.