NAVY Outboard Pylons for McDonnell Douglas F-4 Phantom II (B,J,N,S) (2 pcs) (3D Printed) Scale 1:32 ResKit RS32-0392 for Aircraft Model Kit

ResKit RS32-0392 NAVY Outboard Pylons (2 pcs) is a 3D printed set for 1/32 builds of the McDonnell Douglas F-4 Phantom II (B, J, N, S). It helps refine the outer wing station area with cleaner pylon geometry and sharper edges, so the pylons look straighter and more consistent in close-up viewing.

This set is most noticeable on builds where the pylons remain visible even without stores, or when you want a tidy, symmetrical “unloaded” look under both wings.

For modelers: dry-fit each pylon to the wing first and check the angle left-to-right before primer. If supports are present, remove them in small steps and keep the mating surfaces flat so the pylons sit evenly.

Product Specifications

• Subject: NAVY Outboard Pylons for McDonnell Douglas F-4 Phantom II (B,J,N,S) (2 pcs)
• Scale: 1/32 (also written as 1:32)
• Product type: Pylons / Bomb Racks
• Type of equipment: Aircraft
• Recommended kit: Any / Universal
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS32-0392

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Pylons / Bomb Racks or compare with Pylons / Bomb Racks (all brands). For matching builds, see Aircraft Model Kits and 1/32 Aircraft Model Kits.

FAQ

Are these pylons designed for a specific wing position?

This set represents outboard pylons for the F-4 Phantom II (B, J, N, S). Dry-fit to your kit wing stations to confirm the correct placement and angle.

How do I keep both pylons symmetrical?

Test-fit both sides first and compare angles from the front and rear. Adjust only the mating surfaces so both pylons sit in the same “unloaded” alignment before final glue sets.

Do 3D printed parts need special preparation before painting?

Remove any supports carefully, smooth contact points, and wash the parts before priming. Use thin primer coats to keep edges sharp.