Pivot Pylons for F-111 (A, D, E) with LAU-105 (4 pcs) (3D Printed) Scale 1:48 ResKit RS48-0500 for Aircraft Model Kit

ResKit RS48-0500 provides four pivot pylons with LAU-105 for General Dynamics F-111 Aardvark builds in 1/48, intended for A, D and E versions (kit-dependent). As 3D printed parts, the set is designed to give you sharper pylon edges and cleaner launcher geometry, a visible detail on swing-wing aircraft where stores sit close to the wing glove area.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/48 scale aircraft models.

This set is useful if your kit pylons look simplified, or if you want a more precise pylon-and-launcher look across multiple stations while keeping the geometry consistent from left to right. It is listed as Any / Universal, so final fit to your kit’s pivot points and sweep mechanism detail remains kit-dependent.

For modelers: dry-fit the pylons with the wings in your planned sweep position and confirm clearance before painting. Mark the alignment reference so both wings match, and drill locating holes gradually if needed. Remove supports carefully and keep sanding limited to contact points to preserve crisp edges on the pylons and LAU-105 details.

Product Specifications

• Subject: Pivot Pylons for F-111 (A, D, E) with LAU-105 (4 pcs)
• Variant / Family: F-111 A / D / E (kit-dependent)
• Scale: 1/48 (also written as 1:48)
• Product type: Pylons / Bomb Racks
• Type of equipment: Aircraft
• Recommended kit: Any / Universal
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS48-0500

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Pylons / Bomb Racks or compare with Pylons / Bomb Racks (all brands). For matching builds, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Are these pivot pylons kit-specific?

No. They are listed as Any / Universal, but fit is kit-dependent and depends on your kit’s pivot mounting and wing geometry.

Should I check fit with the wings swept?

Yes. Dry-fit with the wings in your planned sweep position to confirm clearance and alignment before painting and final glue.

How should I prep 3D printed pylons before painting?

Remove supports carefully, wash the parts, and prime with light coats. Keep sanding limited to support contact points to preserve sharp edges.