Pylons for NAVY LTV A-7 Corsair II with MAU-11 Bomb Racks (3D Printing) Scale 1:48 ResKit RS48-0439 for Aircraft Model Kit

ResKit RS48-0439 is a 1/48 pylons with MAU-11 bomb racks set for the NAVY LTV A-7 Corsair II, produced as 3D printed resin parts to provide sharper rack detail and more defined pylon geometry than typical kit parts.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/48 scale aircraft models.

On A-7 builds the pylons and racks are highly visible beneath the wing, especially in full load configurations. Clean attachment points and accurate rack shapes help the stores layout look organized and proportional, while final wing fit and mounting hole positions remain kit-dependent.

For modelers: test-fit the pylons to the wing before painting and confirm alignment from front and rear views, then dry-fit the MAU-11 racks and any planned stores to check spacing; keep primer thin around mounting tabs and clear paint from locating holes for a firm fit.

Product Specifications

• Subject: Pylons for NAVY LTV A-7 Corsair II with MAU-11 Bomb Racks
• Scale: 1/48 (also written as 1:48)
• Product type: Pylons / Bomb Racks
• Type of equipment: Aircraft
• Recommended kit: Any / Universal
• Subject country: USA
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin, 3D Printed
• SKU: RS48-0439

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Pylons / Bomb Racks or compare with Pylons / Bomb Racks (all brands). For matching builds, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Will these pylons fit any 1/48 A-7 kit?

The set is intended as a universal 1/48 accessory for A-7 Corsair II builds, but wing mounting holes and pylon interfaces can vary by kit manufacturer. Test-fit and adjust attachment points if necessary (kit-dependent).

Should I attach the racks before or after painting?

It is usually easier to paint pylons and racks separately, then assemble them once cured. Dry-fit with planned stores beforehand to confirm spacing and alignment.

How do I keep the pylons aligned under the wing?

Check alignment from front and rear views before glue sets and ensure both sides mirror each other. Small adjustments early prevent uneven stores layout later.