R-27ET (AA-10 Alamo-D) missiles (4 pcs) (MiG-29, Su-27, Yak-141) (3D Printed) Scale 1:48 ResKit RS48-0582

ResKit RS48-0582 is a 3D printed set of R-27ET (AA-10 Alamo-D) missiles in 1/48, supplied as 4 pcs for aircraft loadouts. The visual focus is on clean, straight missile bodies and crisp fin edges, helping a full set of four look consistent when mounted as a matched pair on both sides.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/48 scale aircraft models.

Long missiles highlight small differences in alignment and spacing, especially when seen from front and rear angles. This set is intended to refine the look of underwing stores while keeping the final rail/pylon interface dependent on your kit configuration (kit-dependent).

For modelers: check each missile against a flat surface before priming and correct any tilt at the mounting point. Remove supports in stages and sand lightly around contact areas; if your rails are shallow, adding a small pin can help keep all four missiles parallel and evenly spaced.

Compatible aircraft

• MiG-29 Fulcrum,
• Su-27 Flanker,
• Yak-38 Forger

Product Specifications

• Subject: R-27ET (AA-10 Alamo-D) missiles (4 pcs)
• Scale: 1/48 (also written as 1:48)
• Product type: Weapons Set
• Type of equipment: Aircraft
• Recommended kit: Any / Universal - for compatible 1/48 kits (kit-dependent)
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS48-0582

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Arms and Weapons or compare with Arms and Weapons (all brands). For matching builds, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Will these missiles fit any 1/48 kit?

They are listed as Any / Universal, but rails, pylons, and locating points vary by kit. Dry-fit first and adapt the mounting method to your kit setup (kit-dependent).

How do I keep a four-missile loadout looking symmetrical?

Set the same mounting depth and angle on both sides and compare alignment from front and rear views. A simple spacing guide and pinning to the rails can help keep all four parallel.

What is the safest way to clean 3D printed fins and edges?

Cut supports away from thin areas first, then sand only the remaining nubs with light pressure. Prime in thin coats so fin edges stay sharp and do not get rounded over.