R-98 MR/MT missiles (2 pcs) (Su-11, Su-15, Yak-28) (3D Printed) Scale 1:48 ResKit RS48-0574

ResKit RS48-0574 is a 3D printed set of R-98 MR/MT missiles in 1/48, supplied as 2 pcs for aircraft loadouts. The standout improvement is the long, clean missile profile with sharper fin edges and more consistent symmetry, which is especially noticeable on slender stores.

Aftermarket resin accessory designed for aircraft scale model kits.

Highly detailed resin parts intended for accurate 1/48 scale aircraft models.

These missiles typically sit close to the airframe where small alignment issues can be obvious from front and rear views. This set is intended to refine the look of your underwing or fuselage-mounted stores while keeping the final mounting approach dependent on the kit’s pylons or rails (kit-dependent).

For modelers: dry-fit both missiles early and check straightness against a flat surface before priming. When removing supports, work from larger contact points to smaller ones, and use light sanding strokes along the body to avoid creating flat spots on the cylinder.

Compatible aircraft

• Su-11 Fishpot-C,
• Su-15 Flagon,
• Yak-28 Brewer/Firebar

Product Specifications

• Subject: R-98 MR/MT missiles (2 pcs)
• Scale: 1/48 (also written as 1:48)
• Product type: Weapons Set
• Type of equipment: Aircraft
• Recommended kit: Any / Universal - for compatible 1/48 kits (kit-dependent)
• Manufacturer: ResKit
• Country of manufacture: Ukraine
• Material: Resin / 3D Printed
• SKU: RS48-0574

This item is part of ResKit and belongs to Aftermarket. Browse more in ResKit Arms and Weapons or compare with Arms and Weapons (all brands). For matching builds, see Aircraft Model Kits and 1/48 Aircraft Model Kits.

FAQ

Will these missiles fit any 1/48 kit?

They are listed as Any / Universal, but rails, pylons, and locating points vary by kit. Dry-fit first and adapt the attachment method to your kit setup (kit-dependent).

How do I avoid flat spots when cleaning up 3D printed missile bodies?

Sand with light pressure and rotate the part as you work, focusing only on support marks. A thin primer coat will quickly show whether the body stayed evenly round.

What helps keep both missiles aligned the same way?

Match the mounting depth and angle on both sides and check alignment from front and rear. Pinning the missiles to the rail with a short wire can help lock the orientation during final assembly.